DM 2610935540
Right Angle Attachment 575
Before you begin, remove the black protective cap on your attachment. If cap does not slide off easily, insert the shank portion of any accessory through the housing opening of the attachment to hold shaft from rotating. Then twist off. Figure 1.
! CAUTION | Do not use the rotary tool shaft |
| lock button when changing |
|
accessories on the attachment. Internal damage to the attachment may occur.
Remove the housing cap from your existing rotary tool as shown in fig. 2. Then press the shaft lock button on your rotary tool, unscrew the collet nut and remove the collet.
Set your collet nut and collet aside it will be reinstalled later in step 4.
Install the drive adapter, included with your right angle attachment, on the motor shaft as shown in fig.3 and tighten.
! CAUTION | Do not over tighten drive adapter. |
| Tighten the drive adapter finger |
tight and then tighten an additional 1/3 turn with the wrench. (Wrench included with your rotary tool kit)
Screw the attachment onto your rotary tool. Hand tighten only. Reassemble the collet and the collet nut from step 2, on to the output shaft of the attachment. Figure 4.
The right angle attachment can be oriented on your rotary tool in 12 different positions. The attachment should be positioned so the on/off speed control switch is easy to access.
To reposition, unscrew the collar from the attachment until disengaged. Slide the attachment off. Then, reposition, slide the attachment back on the tool and retighten the collar. Figure 5.
To change an accessory, insert the shank portion of any accessory (3,2 mm recommended) through the housing opening of the attachment to hold the shaft from rotating. With the shaft secured, loosen the collet nut and insert an accessory as deeply as possible to avoid wobble during use. You may need to pull back the shank from the housing opening to provide clearance while inserting the accessory. Figure 6.
| Attachment can become hot after | |
! WARNING | ||
prolong usage. |
FIG. 1 | FIG. 2 | FIG. 3 |
FIG. 4 | FIG. 5 |
FIG. 6
3
4 5
Page 17