Hoover hard floor polisher manual Fitting Brushes, Switching the Polisher on, Indicator Lights FIG

GB

FITTING BRUSHES

SAFETY WARNING: The polisher must be switched off and the plug disconnected from the electrical supply before fitting or changing the brushes.

Turn the polisher upside down. Place each brush or pad on its axle and press until a click indicates that it is the correct position. To remove brushes or pads, grasp them and pull towards you.

Your polisher is now ready for use.

SWITCHING THE POLISHER ON

Ensure the handle is in the upright position before inserting the plug into the electricity supply.

To start the polisher push the handle down then lower it into the working position.

To stop the polisher simply return handle to the upright position. SAFETY WARNING: Do not run over main leads to avoid damage to the electrical insulation.

INDICATOR LIGHTS (FIG. 6)

(Depending on model)

Some polishers will have 4 indicator lights on the front panel: Green light on: the appliance is connected to the electricity supply Red light on: paper dust bag needs changing

1 orange light on: motor running at low speed

2 orange lights on: motor running at normal speed

ADJUSTING BRUSH SPEED (FIGS 6 & 7)

(Depending on model)

Models equipped with 4 indicator lights on panel (Fig. 6), are supplied with a 2 - position foot switch (Fig. 7). During the wax-spreading phase with the Yellow or Black brushes, press the foot switch to reduce brush rotation speed, reduce noise level and save energy. When the rotation speed is low one Orange light is illuminated When the wax-spreading operation is finished, press the foot switch (Fig. 7) to return to high speed and start the polishing phase.

When the rotation speed is high two Orange lights are illuminated SAFETY WARNING: The polisher must be switched off and the plug disconnected from the electrical supply before fitting or changing the brushes.

4