A
Fig. 11
A 
Fig. 12
B
Tap container lightly to remove compacted dust. DO NOT WASH CONTAINER. Dry compressed air may be used to blow out container.
A
B
Fig. 13
Wear ANSI Z87.1 safety glasses while using compressed air.
ACCESSORY PADS
Model 340 is supplied with a Standard Profile, PSA (Pressure Sensitive Adhesive) Pad. This pad and some special purpose pads are available to fit this machine. To install one of these accessory pads:
DISCONNECT TOOL FROM POWER SOURCE.
1.Remove abrasive from sander.
2.Use a T20 Torx screwdriver to remove the four pad retaining screws (Fig. 14), and lift the foam pad (and its aluminum backing plate), off the sander.
3.Position the accessory pad to the sander and attach with the four screws from Step 2.
Fig. 14
13