Schumacher NIN-812A, 94085894, 00-99-000943 owner manual Limited warranty, Your Battery

Page 15

“bAd bAt” in Display; CON-

The charger is in abort

See the “USING

NECTED LED lit.

mode. The battery may be

YOUR BATTERY

 

bad.

CHARGER” section.

See Aborted Charge in the

This will happen if the

Reset the charger by

“Operating Instructions”

battery did not reach full

unplugging it. Select

section.

charge within 24 hours.

the desired battery

 

May be due to a very large

type again, if neces-

 

battery or bank of batteries

sary.

 

requiring more power than

 

 

the charger can deliver in

 

 

24 hours. The charger is

 

 

in abort mode. The battery

 

 

may also be faulty.

 

The charger is making an

The charger has a relay that

No problem, this is a

audible clicking sound.

turns the current on and off

normal condition.

 

to the battery.

 

The measured current is

The charger reached the

No problem, this is a

much lower than what was

maximum voltage and is

normal condition.

selected.

reducing the current.

 

 

The charger detected an

Make sure the char-

 

over-temperature condition

ger does not have the

 

and has reduced the current

side ventilation holes

 

to allow the unit to cool.

blocked. Move the

 

 

charger out of the sun

 

 

and into the shade.

The charger was unplugged

The battery is supplying the

Disconnect the bat-

from the wall but the display

power to the display.

tery.

is still on.

 

 

While charging the battery,

The % display may not

DO NOT UNPLUG

the battery stays at a cer-

change at a steady rate.

OR CHANGE SET-

tain % (ex. <65%).

 

TING. Be patient and

 

 

let the charger finish.

 

 

This is normal.

When the charger is

The battery voltage is still

Wait for the voltage to

unplugged or the settings

high from a partial charge.

settle before resum-

are changed, the number

 

ing the charge. Try

increases or jumps to 100%.

 

to charge at a lower

 

 

charge rate. Turn on

 

 

the lights to remove

 

 

the surface charge.

17.limited warranty

SCHUMACHER ELECTRIC CORPORATION, 801 BUSINESS CENTER DRIVE, MOUNT PROSPECT, IL 60056-2179, MAKES THIS LIMITED WARRANTY TO THE ORIGINAL RETAIL PURCHASER OF THIS PROD- UCT. THIS LIMITED WARRANTY IS NOT TRANSFERABLE OR AS- SIGNABLE.

11

Image 15
Contents Guide D’UTILISATION Page Table of Contents / Índice / Table DES Matières Page Important Safety Instructions Never charge a frozen battery Never overcharge a battery DC Connection Precautions Preparing to ChargeCharger Location Follow These Steps When Battery is Outside Vehicle Follow These Steps When Battery is Installed in VehicleGrounding Methods Battery charging ac connectionsDigital Display Button Assembly instructionsBattery Type Button Control panelOverview Operating instructionsGeneral Charging Notes Using the volt meter to test battery state of chargeDuration of the charging process depends on three factors Battery percent and charge timeStorage instructions Maintenance instructionsTroubleshooting Problem Possible Cause SolutionYour Battery Limited warrantyPage Instrucciones DE Seguridad Importantes Ácido Ubicación DEL Cargador Preparación Para LA CargaPrecauciones DE Conexión EN CC Bateria Cargando Conexiones AC Instrucciones DE Ensamblaje Métodos a tierra10.2 Botón de Battery Type Instrucciones DE Funcionamiento Aspectos Generales Notas Generales Relacionadas CON LA Carga La duración del proceso de carga depende de tres factores Porcentaje DE Batería Y Tiempo DE CargaInstrucciones DE Mantenimiento Instrucciones DE Almacenaje Localización Y Solución DE Problemas Causa PosibleCambie LAS CON Problema Causa Posible SoluciónPage Page Page Préparation Pour LE Chargement Emplacement DU ChargeurPrécautions SUR LA Connexion C.C Chargement D’UNE Batterie Raccordements C.A Directives DE Montage Aucun montage n’est nécessaire Bouton du mode d’affichage Panneau DE ContrôleSélecteur de type de batterie Consignes D’UTILISATION Aperçu Page Pourcentage DE LA Batterie ET Durée DE Charge Consignes D’ENTRETIEN La durée du processus de charge dépend de trois facteursDirectives D’ENTREPOSAGE Tableau DE Dépannage Problème Cause Possible SolutionNE PAS Débranch