Warning: Safety
Precautions
The following pages contain detailed warnings, cautions, and rules of safe operation. Read carefully and become familiar before operating to avoid serious injury. We expressly disclaim any liability for any injury to persons or damage to property which result from your failure to take the precautions contained in this manual.
WARNING: This tool is designed only for use by qualified operators. Qualification is obtained through a thorough under- standing of the Safety Precautions and operating instructions as defined in this operating manual. NOTE: The labor regula- tions of many states require that the operator of this tool on a job site be thoroughly trained and certified for competence prior to operating this tool. For certification procedures, call: DESA Power Tools™ Technical Services Department,
BEFORE USING
1.ALWAYS handle the tool
as if it were loaded. Before | ? | ? |
starting work, check that | ||
the tool is unloaded and |
|
|
the muzzle is clear. NEVER |
|
|
load a tool unless it is going |
|
|
to be used. |
|
|
2.ALWAYS inspect to make sure the tool is working properly. If the tool does not work properly, remove from service and tag DEFECTIVE. DO NOT use the tool again until it has been properly repaired.
3.Operators and bystanders must ALWAYS wear goggles and ear protection which meet or exceed the accepted standards for adequate protection in your country. In the USA, refer to ANSI standards. In Canada, refer to CSA standards.
119586