Black & Decker LDX116 Charging Procedure, Long storage will not harm the battery pack or charger

Page 6

may ignite the dust or fumes.

If battery contents come into contact with the skin, immediately wash area with mild soap and water. If battery liquid gets into the eye, rinse water over the open eye for 15 minutes or until irritation ceases. If medical attention is needed, the battery electrolyte for Lithium-Ion batteries is composed of a mixture of liquid organic carbonates and lithium salts.

Contents of opened battery cells may cause respiratory irritation. Provide fresh air. If symptoms persist, seek medical attention.

WARNING: Burn hazard. Battery liquid may be flammable if exposed to spark or flame.

Charge the battery packs only in Black & Decker chargers.

DO NOT splash or immerse in water or other liquids. This may cause premature cell failure.

Do not store or use the tool and battery pack in locations where the temperature may

 

reach or exceed 105°F (40˚C) (such as outside sheds or metal buildings in summer).

 

WARNING: Never attempt to open the battery pack for any reason. If battery pack

case is cracked or damaged, do not insert into charger. Do not crush, drop or damage battery pack. Do not use a battery pack or charger that has received a sharp blow, been dropped, run over or damaged in any way (i.e., pierced with a nail, hit with a hammer, stepped on). Damaged battery packs should be returned to service center for recycling.

WARNING: Fire hazard. Do not store or carry battery so that metal objects can contact exposed battery terminals. For example, do not place battery in aprons, pockets, tool boxes, product kit boxes, drawers, etc., with loose nails, screws, keys, etc.

Transporting batteries can possibly cause fires if the battery terminals inadvertently come in contact with conductive materials such as keys, coins, hand tools and the like. The US Department of Transportation Hazardous Material Regulations (HMR) actually prohibit transporting batteries in commerce or on airplanes (i.e., packed in suitcases and carry-on luggage) UNLESS they are properly protected from short circuits. So when transporting individual batteries, make sure that the battery terminals are protected and well insulated from materials that could contact them and cause a short circuit. NOTE: Lithium-

Ion batteries should not be put in checked baggage.

Storage Recommendations

 

1. The best storage place is one that is cool and dry away from direct sunlight and excess heat or cold.

2. Long storage will not harm the battery pack or charger.

 

Charging Procedure

A

Black & Decker chargers are designed to charge

Black & Decker battery packs in 3-4 hours depending

 

on the pack being charged.

 

1. Plug the charger into an appropriate outlet before

 

inserting the battery pack.

 

2. Insert the battery pack into the charger as shown in

 

figure A.

 

3. The green LED will flash indicating that the battery is

 

being charged.

 

4. The completion of charge is indicated by the green

 

LED remaining on continuously. The pack is fully

 

charged and may be used at this time or left on the

 

charger.

 

Recharge discharged batteries as soon as possible after use or battery life may be greatly diminished. For longest battery life, do not discharge batteries fully. It is recommended that the batteries be recharged after each use.

Leaving the battery in the charger

The charger and battery pack can be left connected with the green LED glowing indefinitely. The charger will keep the battery pack fresh and fully charged.

Important Charging Notes

1. Longest life and best performance can be obtained if the battery pack is charged when the air temperature is between 65°F and 75°F (18°- 24°C). DO NOT charge the battery pack in an air temperature below +40°F (+4.5°C), or above +105°F (+40.5°C). This is important and will prevent serious damage to the battery pack.

2. The charger and battery pack may become warm to touch while charging. This is a normal condition, and does not indicate a problem. To facilitate the cooling of the battery pack after use, avoid placing the charger or battery pack in a warm environment such as in a metal shed, or an uninsulated trailer.

3. If the battery pack does not charge properly:

a. Check current at receptacle by plugging in a lamp or other appliance 6

Image 6
Contents 16V MAX* & 20V max** Cordless drills Safety Guidelines Definitions Work Area SafetySpecific Safety Rules Important Safety Instructions for Battery Chargers FUNCTIONAL DESCRIPTION Black & Decker chargers are designed to charge Charging ProcedureLong storage will not harm the battery pack or charger Important Charging NotesSafety Warnings and Instructions Drills Installing and Removing the Battery Pack From the ToolTorque Control Figure E Trigger Switch & Reversing Button Figure DOperating Instructions Keyless Chuck Figure FOn board bit storage Figure G Make sure switch turns drill on and off Drilling in WoodMaintenance DrillingBattery TroubleshootingProblem Possible Cause Possible Solution Rbrc SealSee ‘Tools Service Information Full Two-Year Home Use WarrantyFor Service Electric’Perceuse Sans FIL DE 16V MAX*, 20V MAX Lignes directrices en matière de sécurité définitions Réparation Règles de sécurité spécifiques · le plomb dans les peintures à base de plombDescription Fonctionnelle Lire toutes les directives Calibre de fil minimum recommandé pour les rallongesDirectives de sécurité importantes pour les blocs-piles Longueur totale de la rallongeBloc-piles laissé dans le chargeur Recommandations en matière de rangementProcédure de charge Remarques importantes pour le chargementAvertissement de sécurité et directives perceuses Centre de réparation de votre régionInsertion et retrait du bloc-piles de l’outil Réglage du couple figure e Avertissement S’assurer que leDétente ET Bouton Inverseur Mandrin sans clé figure FPerçage DU Bois VissagePerçage Perçage DU MétalLe sceau Rbrcmc AccessoiresProblème Dépannage Solution possible Cause possible Maximiser la durée de vie duVoir la rubrique Pour le service et les ventesInformation sur les réparations Outils électriquesTaladro Inalámbrico DE 16V MÁX*, 20V MÁX Pautas DE SEGURIDAD/DEFINICIONES Seguridad eléctricaNormas de seguridad específicas Símbolos Control podría ocasionar lesiones personalesDaños personales y materiales Nunca intente conectar 2 cargadores juntos Lea todas las instruccionesLongitud total del cable Voltios. No intente utilizarlo con otro voltajeCondiciones adecuada Recomendaciones con respecto al almacenamientoDirecta y de un exceso de calor o frío Procedimiento de cargaBaterías y el cargador al centro de mantenimiento local La herramientaInterruptor Disparador Y Botón DE Inversión Figura D Ajuste del control de torsión Figura EPortabrocas sin llave Figura F Taladrado en metal DestornilladoTaladrado Taladrado en mamposteríaEl sello Rbrc MantenimientoAccesorios Maximizar la vida útil del Paquete de baterías, esteSolamente para Propósitos de México Page Telephone · No. Teléfono Años DE GarantiaEsta Garantia no Aplica Cuando Page Page Solamente Para Propositos DE Mexico
Related manuals
Manual 21 pages 669 b