Sharp FP-N40CX Remote Control Limitations, Installation Guidelines, Filter Guidelines

Page 9

CAUTIONS CONCERNING THE OPERATION OF THIS PRODUCT

Do not block the intake and air outlet.

Do not use the unit near or on hot objects, such as a stove. Also, do not use the unit where it may come into contact with steam.

Do not use the unit on its side.

Deformation, malfunction and/or overheating of the motor may occur as a result.

Do not install when there is generation of oily residue, such as in a kitchen.

Do not use detergent when cleaning the unit. The unit surface may become damaged or cracked. In addition, the sensor may malfunction as a result.

Do not operate the unit without the filter.

It will have no purification effect. In addition, it becomes the cause of the trouble.

Do not wash and reuse HEPA filter.

Not only it does not improve filter performance, it may cause electric shock or malfunction.

Let Washable Active Carbon Filter dry thoroughly after cleaning it. Wet filter may damage HEPA filter, and it may cause strong odor.

When transporting the unit, always hold the handle on the back of the unit.

Holding the front panel when carrying may cause it to detach, thus dropping the unit and resulting in bodily injury.

REMOTE CONTROL LIMITATIONS

DO NOT USE THE REMOTE CONTROL IN THE FOLLOWING LOCATIONS

Any location where there is inverter lighting equipment or electronic spontaneous lighting equipment

The remote control may become inoperative. In this case, move away from such lighting equipment or change direction.

Location exposed to direct sunlight

The unit may not receive signals from the remote control.

The unit may not respond to the signals of the remote control if the ends of fluorescent lighting become black or lights flicker due to the depletion of service life; however, this is not a malfunction of the remote control or the main unit. In this case, replace the lighting with new fluorescent tubes.

INSTALLATION GUIDELINES

Leave at least 7 feet (2m) of space from equipments which involve electric wave such as televisions, radios or wave clocks.

Electrical interference may occur if not.

Leave at least 2 feet (60cm) of space from the wall The motor may overheat, causing malfunction if not.

Avoid a location where sensor is exposed to direct wind The unit may not operate properly.

Avoid a location where curtains, etc., come into contact with the intake or air outlet. Curtains, etc., may become dirty or malfunction may occur as a result.

EFFECTIVE OPERATION

• Place on a stable surface with sufficient air circulation

FILTER GUIDELINES

Do not wash and reuse the True HEPA Filter. It does not work effectively, and may become a cause of electric shock.

The wall behind the air outlet may become dirty as time passes. When using the unit for extensive period in the same location, use a vinyl sheet, etc., to prevent the wall from becoming dirty. In addi-

tion, periodically clean the wall, etc.

E-7

ENGLISH

Image 9
Contents Floor / Tabletop type Type mobile FP-N40CXPage Features Filter MaintenanceContents For Your Protection the United States Consumer Limited Warranty for the U.S. Users Consumer Limited WarrantyFor Your Protection Canada Limited Warranty Periodically remove dust from the power plug Safety PrecautionsRisk of Electric Shock Use AC 120V onlyRemote Control Limitations Installation GuidelinesFilter Guidelines CLEAN-SIGN Light Part NamesMain Unit Display Accessories PlasmaclusterindicatorlightMounting the Stand BackInserting Batteries in the Remote Control Filter InstallationBattery Information PreparationFilter Installation Remote Control USEMain Unit Controls Main Unit OperationAuto CleanIon Control OffCare and Maintenance Washable Active Carbon Filter CareCare Cycle Filter Cleaning Odor Sensor Main UnitReplacing the Filters Filter Replacement GuidelinesReplacing After replacing the filtersCan this filter be washed? When should I wash this filter? Operation GuideWill washing improve the filter’s performance? Remedy not a malfunction TroubleshootingStandby Power SpecificationsEnglish Page Caractéristiques Entretien DU FiltreTable DES Matières Pour Téléphoner Composez le 1-905-568-7140 pour Pour Vous ProtégerGarantie Limitée Précautions DE Sécurité Risque D’ÉLECTROCUTIONUtilisation uniquement avec du 120 V alternatif Guide D’INSTALLATION Limitations DE LA TélécommandePrécautions Concernant LE Fonctionnement DE CET Appareil Guide D’UTILISATION DU FiltreAffichage DE L’UNITÉ Principale Désignation DES PiècesVoyant de filtre VentilateurAccessoires DOS DE L’APPAREILRetirez le panneau avant Au sujet des piles Installation DU FiltreRemplacement du filtre Utilisation DE LA TélécommandeDans les coins supérieurs Utilisez la date pour déterminer la période deDE L’UNITÉ FonctionnementPrincipale AutoLA Télécommande Automatique Auto Nettoyage CleanContrôle d’ions ION Control Désactivé OFF Cycle d’entretien Soin ET EntretienTrempez le filtre environ 30 min- utes avant de le laver Rincez abondamment avec de l’eau propreNettoyagedufiltre Capteur D’ODEUR Unité PrincipaleRemplacement DES Filtres Guide DE Remplacement DES FiltresCas de remplacement Après le remplacement des filtresLe lavage va-t-il améliorer l’efficacité du filtre ? Guide D’UTILISATIONSolution pas un dysfonctionnement Résolution DES ProblèmesConsommation en veille CaractéristiquesEnglish Osaka, Japan New Jersey 07430-2135 U.S.A