HP LH 6000 manual Leveler Feet Anti-Tip Foot

Chapter 1 General Information

Leveler

Feet

Anti-Tip Foot

Rack Anti-tip Foot

2.Remove the bezel from the front of the HP NetServer by swinging the bezel open (past 90 degrees) until it releases from the three posts on the bezel hinge.

Removing the HP NetServer LH 6000r Bezel

3.Use a Torx 15 screwdriver to unscrew the four screws securing the HP NetServer to the rack.

4.Do not unscrew the entire hinge or bracket from the HP NetServer. Remove only the outer screws so the hinge and the bracket remain attached to the HP NetServer chassis.

4