HP LH 6000 manual CD-ROM drive has reported an error during its self-test

Chapter 4 Diagnostics

4.If the problem persists, your flexible disk drive may need to be replaced. Contact your service representative.

0306 The system board self-test has detected a general failure on the integrated flexible disk controller.

Your system board may need to be replaced. Contact your service representative.

0310 The flexible disk drive A is not responding but is configured in the Setup utility.

1.If the flexible disk drive A has just been removed, press [F4] to automatically validate the change.

2.Otherwise, check that all cables and power cords are firmly connected.

3.If the problem persists, your flexible disk drive may need to be replaced. Contact your service representative.

0400 The CD-ROM drive has reported an error during its self-test.

1.If a CD-ROM disk is present, check that it is correctly inserted.

2.Check that CD-ROM drive door or tray has not been opened or closed during the self-test.

3.Check that all cables and power cords are firmly connected.

4.If the problem persists, your CD-ROM drive may need to be replaced. Contact your service representative.

0401 The CD-ROM drive is not responding but is configured in the Setup utility.

1.If the CD-ROM drive has just been removed, press [F4] to automatically validate the change.

2.Check that all cables and power cords are firmly connected.

3.If the cable is damaged, connect the hard disk drive to another IDE cable, if available.

4.If the problem persists, your CD-ROM drive may need to be replaced. Contact your service representative.

0500 The system board self-test has detected a general failure on the integrated hard disk controller.

Your system board may need to be replaced. Contact your service representative.

051X The specified hard disk drive has reported an error during its self-test.

1.Check the hard disk drive configuration with the Setup utility. If necessary, edit the user hard disk parameters to set lower values.

2.If the problem persists, your drive may need to be replaced. Contact your service representative and specify the error code.

Error codes #0510, #0511, #0512, #0513 respectively apply to IDE0, IDE1, IDE2, and IDE3 as described in the Setup utility.

052X The specified hard disk drive is not responding but is configured in the Setup utility.

1.If the specified hard disk has just been removed, press [F4] to automatically validate the change.

2.Check that all cables and power cords are firmly connected.

51