HP LH 6000 manual Replacing the Rear Chassis Fans

Chapter 6 Replacing Parts

Removing the Power Supply Fan Assembly

Install the new fan assembly by using the above procedures in reverse.

Replacing the Rear Chassis Fans

The rear chassis fans are individually mounted just to the rear of the system board assembly. These fans are individually replaceable and may be hot-swapped.

CAUTION Do not run this NetServer for more than 60 minutes without all covers in place. Any component being replaced must be removed and a replacement installed within this 60-minute time window. If you feel that you cannot, in your estimate, replace any particular component within this time, first turn off power to the system and then replace the component. Failure to replace the covers within 60 minutes may result in damage to system components due to lack of cooling air.

Follow these instructions to remove and replace the chassis fans:

1.Back up the hard disk drive(s) and save the configuration.

2.If necessary, shutdown the network operating system.

3.Turn off the HP NetServer and display.

4.Disconnect all telephone cables and power cords.

5.Remove the side cover.

6.Remove the individual fan assembly by pressing the handles and pulling the assembly out of the chassis.

Removing a Rear Chassis Fan

Install the new fan assembly by using the above procedures in reverse.

91