HP LH 6000 manual General Information, Removing Covers Pedestal LH6000

1 General Information

Notice to Service Technicians

This is the service document for the HP NetServer LH6000 server. You also need to access the HP NetServer LH6000 Installation Guide which comes with the server and is also available on the Network Server Division WEB site and on the Information Assistant Documentation CD-ROM.

The LH6000 installation guide contains additional information on the installation process that the end users follow. Both documents are needed for complete servicing information.

Removing Covers - Pedestal LH6000

WARNING Before removing covers, disconnect the power cords and unplug telephone cables. If possible, shut down the operating system. Disconnect the power cords to avoid exposure to high energy levels that may cause burns when parts are short-circuited by metal objects, such as tools or jewelry. Disconnect telephone cables to avoid exposure to shock hazard from telephone ringing voltages.

Wear a grounded wrist strap and use a static-dissipating work surface when handling NetServer components. Note that the power switch does not turn off the standby power. Disconnect the power cords to turn off standby power.

NOTE If the backlight of the LCD is on, standby power is also on.

1.Unlock the bezel, using the supplied key.

The bezel connects to the chassis with two snap-in connectors inside its top left and right corners and two tabs that fit into two slots on the bottom of the chassis.

2.Remove the bezel.

a.Pull bezel toward you until it unsnaps.

b.Lift the bezel forward and upward from the chassis face.

1