HP LH 6000 manual Front Panel Console Switch and Indicator Descriptions

Chapter 1General Information

Front Panel Console Switch and Indicator Descriptions

Control	Description
DC Power Switch	Turns the HP NetServer on and off. This switch is under the door on the front panel.
and LED	Push once to turn on, again to turn off. As long as the AC power is connected to the
	HP NetServer, standby power is present.
	l If the LED is steady green, then the HP NetServer is powered-up.
	l If the LED is flashing green, the HP NetServer is in a power-save mode.
	l If the LED is off, but the two-line display has a message, standby power is
	present.
	l To go into power-save mode, depress the power switch; you must press it for
	over ten seconds to effect a power down.

RESET Or

Resets the HP NetServer. This switch may be disabled by Secure mode.

RESET

Secure Mode

Switch and

Indicator

Locks system keyboard, monitor display, and control panel to prevent unauthorized use. Go to the Setup utility security menu to configure this feature. Secure Mode indicator illuminates when Secure Mode is enabled.

Status screen		Reports system status.
Red	Yellow	Green
LED	LED	LED	Indicates HP NetServer Status:
Off	Off	Off	Main power is off and the HP NetServer may or may not be on standby
			power.
Flashing	Off	Off	Immediate attention required due to a failed component in the HP
			NetServer. The HP NetServer may not be fully operational, due to this
			condition, such as POST errors.
Off	Flashing	Off	Attention required due to a pre-failure condition. This condition may be
			caused by a component failure (for example, a redundant fan or power
			supply) that could lead to a critical component failure, such as a processor
			module exceeding its operating temperature. If the failed component is
			redundant, the HP NetServer may still be operating normally.
Off	Off	On	The HP NetServer is operating normally.

11