HP LH 6000 manual Replacing the Power Management/Interconnect Board

Chapter 6 Replacing Parts

7.Remove the DIMMs. Note positions of the DIMMs for reinstallation.

8.Record the configuration switch settings for setting the replacement system board.

9.Replace the system board with the new system board.

10.Set the configuration switches

11.Reassemble the System Board Assembly.

12.Reset the time and date if necessary.

Replacing the Power Management/Interconnect Board

The replacement procedure is the same for the rack-mount and the pedestal HP NetServers once you gain access to the Power Management/Interconnection board.

1.Log off all users and gracefully shut down the network operating system according to directions in your NOS documentation.

2.Power down the HP NetServer.

3.Disconnect the power cords and cables, and if necessary, label each one to support re- assembly.

CAUTION The power supplies will continue to provide standby current to the NetServer until the power is disconnected.

4.For both rack-mounted and pedestal models, gain access to the Power Management/Interconnection board.

WARNING Always disconnect the power cords before removing the covers, to avoid exposure to high energy levels that may cause burns when parts are short-circuited by metal objects such as tools or jewelry. Disconnect any telephone cables to avoid exposure to shock hazard from telephone ringing voltages.

5.Remove the rear chassis fans.

6.Remove the power supply fans.

7.Remove the accessory fans.

8.Remove the System Board Assembly.

9.Remove the I/O Board.

10.Remove all cables connecting to the Power Management/Interconnection board (see figures, below).

NOTE	Cables are connected to both the bottom and top of the Power
	Management/Interconnection board. Be sure to disconnect all cables before
	removing the Power Management/Interconnection board.

11.Remove the eight screws holding the Power Management/Interconnection board to the chassis (see figures).

101