HP LH 6000 manual System Board Assembly and Configuration Switch

Chapter 5 Troubleshooting

2.Power down the HP NetServer.

3.Disconnect the power cords and cables and, if necessary, label each one to support re- assembly.

CAUTION The power supplies will continue to provide standby current to the NetServer until the power is disconnected.

4.For both rack-mounted and pedestal models, remove the covers to gain access to the system board assembly.

NOTE	In the LH 6000r, this assembly is under the right cover; in the LH 6000, it is under
	the top cover.

While you can clear the system configuration in the rack or in the pedestal, it is recommended that you remove the system board assembly to perform configuration changes

1

2

3

4

5

6

7

8

OCPU Speed N CPU Speed CPU Speed

Clear Config Clear Password

Not Used

Switches1and 4 of dual in-line switch, S1, shown in the ON position.

System Board Assembly and Configuration Switch

5.Move the configuration switch, switch 5 on the system board, to the "ON = CLEAR CONFIG" position.

58