Sterling BP1012, BP1018 installation manual Checking Rotation Direction, Removing the Screw Knob

Page 27

4.Pivot back the feed hopper to gain free access to the cutting chamber.

5.Check that there are no foreign objects in the cutting chamber.

6.Check to be sure the bed knife and rotor knife bolts are at the proper torque and the knife gap is set according to specifications. See Sections 4-4-4 and 6-4.

7.After completing the checks, close the hopper and screen, and fasten them with the corresponding knobs; reinsert the bin. Then close both the rear cover and the front panel.

8.Remove the drive belt guard by unscrewing the ten fastening screws.

9.Manually give the rotor at least one complete turn using the rotor pulley.

10.If there are no warning noises or signs of friction, this means the cutting chamber is completely clear. Replace the belt guard, remove lockout devices, and turn power on.

Figure 11: Removing the Screw Knob

4-4-2 Checking Rotation Direction

Check the correct direction of the rotor as follows:

1.Turn the main disconnect switch to “ON”.

2.Pull the Start button until the motor comes up to speed; then push the button to stop the granulator motor.

3.Check via the appropriate window that the rotor direction corresponds to that shown on the arrow label that is located above the guard.

Page 27 of 53

Image 27
Contents BP1000 Series Granulators Page Sterling Warranty Information Sterling Warranty Information Table of Contents Start Up and Operation Table of Figures Viii Safety Guidelines Safety ConsiderationsPage Safety Procedures Guidelines for Moving the GranulatorClearing a Jammed Cutting Chamber Safety Features Fitted On the Granulator Safety FeaturesOpening the Granulator Safety SwitchSound Enclosure Wear protective gloves when exposed to knivesModel Motor Power Noise Test Method Using This Manual General InformationIntroduction Description Safety Symbols Used in This ManualOptional Equipment Main Components of Standard GranulatorsModel If the Shipment is Not Complete Shipping InformationUnpacking and Inspection Event of Shipping DamageIf the Shipment is Not Correct ReturnsUncrating Your Granulator Especially the Hopper Installation LiftingPositioning the Granulator Inserting the Bin Electrical ConnectionChecking the Cutting Chamber Start-Up ChecksRemoving the Screw Knob Checking Rotation DirectionChecking Knife Position Test the Interlock SwitchesChecking the Knife Gap Start Up and Operation Pre-Operational ChecklistNever push material into the hopper with hands OperationGeneral Recommendations MaintenanceMonthly Maintenance Operations Drive Belt TensionProper Belt Tension Belt Replacement Removal and Replacement of the ScreenRemoving the Screen Inspection and Adjustment of KnivesPage Inspection of Knives Removing and Replacing Bed KnivesRemoval and Replacement of Rotating Blades Specifications for Re-sharpening Bed Knives Bed Knife Specifications Specifications for Re-sharpening Rotor KnivesGeneral Problems 7TroubleshootingProblem Possible Causes Possible Remedies Electrical Problems Spare Parts Recommended Spare Parts ListCutting Chamber Vertical Cross Section Cutting Chamber Longitudal Cross Section Cutting Chamber Front View Cutting Chamber Rear View Typical Wiring Diagram Parts Department Contact InformationService Notes Warranty