Sterling BP1018, BP1012 installation manual Sterling Warranty Information

Page 4

Sterling Warranty Information

We warrant our product to be of the kind and quality quoted, and no other warranty except of title shall be implied. Our company shall repair or replace, at our discretion, any manufactured item on your BP1000 Series Granulator without charge FOB factory, within one (1) year after date of original purchase, which is proved to be defective when shipped. Claims for labor or consequential damages are not allowed.

Excluded from the above are knives, screens, and belts. Purchased items, including electrical components, motors, etc., shall carry the warranty of the supplier and no extension of that warranty is allowed.

Refer to this manual for assistance in installing and maintaining a highly efficient machine. Questions regarding areas that are not covered in the manual should be referred to the customer service manager at the factory at (800) 229-2919.

Page iv of 53

Image 4

Contents BP1000 Series Granulators Page Sterling Warranty Information Sterling Warranty Information Table of Contents Start Up and Operation Table of Figures Viii Safety Considerations Safety GuidelinesPage Guidelines for Moving the Granulator Safety ProceduresClearing a Jammed Cutting Chamber Safety Features Safety Features Fitted On the GranulatorSafety Switch Opening the GranulatorWear protective gloves when exposed to knives Sound EnclosureModel Motor Power Noise Test Method General Information Using This ManualIntroduction Safety Symbols Used in This Manual DescriptionMain Components of Standard Granulators Optional EquipmentModel Shipping Information Unpacking and InspectionEvent of Shipping Damage If the Shipment is Not CompleteReturns If the Shipment is Not CorrectUncrating Your Granulator Especially the Hopper Lifting InstallationPositioning the Granulator Electrical Connection Inserting the BinStart-Up Checks Checking the Cutting ChamberChecking Rotation Direction Removing the Screw KnobTest the Interlock Switches Checking Knife PositionChecking the Knife Gap Pre-Operational Checklist Start Up and OperationOperation Never push material into the hopper with handsMaintenance General RecommendationsDrive Belt Tension Monthly Maintenance OperationsProper Belt Tension Removal and Replacement of the Screen Belt ReplacementInspection and Adjustment of Knives Removing the ScreenPage Removing and Replacing Bed Knives Inspection of KnivesRemoval and Replacement of Rotating Blades Specifications for Re-sharpening Bed Knives Specifications for Re-sharpening Rotor Knives Bed Knife Specifications7Troubleshooting General ProblemsProblem Possible Causes Possible Remedies Electrical Problems Recommended Spare Parts List Spare PartsCutting Chamber Vertical Cross Section Cutting Chamber Longitudal Cross Section Cutting Chamber Front View Cutting Chamber Rear View Typical Wiring Diagram Contact Information Parts DepartmentService Notes Warranty