Sterling BP1018, BP1012 installation manual Recommended Spare Parts List

Page 44

8	Spare Parts

When requesting spare parts, always quote the granulator model and serial number (from the granulator label), as well as the table number and reference number (from the spare parts tables) and the quantity required.

8-1		Table 1: Recommended Spare Parts List

	Item			1012			1018			Material
				Quantity			Quantity
	Rotor Knife		3			3				HCHC
	Rotor Knife Screw		12			15				GR 10.9 M12 x 40MM
	Bed Knife		2			2				HCHC
	Bed Knife Screw		8			10				GR 10.9 M12 x 60MM
	Bed Knife Washer		8			10				Hardened
	Screen		1			1				Specify Hole Size Required
	Rotor Bearing		2			2				65MM Bore
	Drive Belt		2			2				Qty. Depends on HP
	Bed Knife Adj. Screw		4			4				GR
	Interlock Switch		1			1

∗When ordering a screen, always specify the diameter of the holes required.

Page 44 of 53

Image 44

Contents BP1000 Series Granulators Page Sterling Warranty Information Sterling Warranty Information Table of Contents Start Up and Operation Table of Figures Viii Safety Considerations Safety GuidelinesPage Clearing a Jammed Cutting Chamber Safety ProceduresGuidelines for Moving the Granulator Safety Features Safety Features Fitted On the GranulatorSafety Switch Opening the GranulatorWear protective gloves when exposed to knives Sound EnclosureModel Motor Power Noise Test Method Introduction Using This ManualGeneral Information Safety Symbols Used in This Manual DescriptionMain Components of Standard Granulators Optional EquipmentModel Shipping Information Unpacking and InspectionEvent of Shipping Damage If the Shipment is Not CompleteUncrating Your Granulator If the Shipment is Not CorrectReturns Especially the Hopper Positioning the Granulator InstallationLifting Electrical Connection Inserting the BinStart-Up Checks Checking the Cutting ChamberChecking Rotation Direction Removing the Screw KnobTest the Interlock Switches Checking Knife PositionChecking the Knife Gap Pre-Operational Checklist Start Up and OperationOperation Never push material into the hopper with handsMaintenance General RecommendationsProper Belt Tension Monthly Maintenance OperationsDrive Belt Tension Removal and Replacement of the Screen Belt ReplacementInspection and Adjustment of Knives Removing the ScreenPage Removing and Replacing Bed Knives Inspection of KnivesRemoval and Replacement of Rotating Blades Specifications for Re-sharpening Bed Knives Specifications for Re-sharpening Rotor Knives Bed Knife Specifications7Troubleshooting General ProblemsProblem Possible Causes Possible Remedies Electrical Problems Recommended Spare Parts List Spare PartsCutting Chamber Vertical Cross Section Cutting Chamber Longitudal Cross Section Cutting Chamber Front View Cutting Chamber Rear View Typical Wiring Diagram Contact Information Parts DepartmentService Notes Warranty