38 (!4,0
Note
$
1Make sure the digital sender is idle.
2At the control panel, press SETUP (ALT+F4). Then press SETTINGS (F2).
3Select any of the configuration menus. If an administrator password is required, the HP Digital Sender 8100C Administrator’s Password dialog box appears. Type the password and press OK (F1).
4When the configuration menu appears, press TOOLS (F2).
5Select Shutdown and press OK (F1).
A shutdown key sequence exists that will shut down the digital sender if it becomes unresponsive and therefore will not navigate to the Shutdown option. The code is:
SHIFT+ALT+ 
.
,
Use this procedure for the following reasons:
●when you want to completely reconfigure the digital sender and all address books
●when instructed to do so by troubleshooting steps or HPcustomer support
Resetting the digital sender to factory defaults is a combination of resetting address books and resetting network parameters. It does the following:
●erases the administrator password
●locks the digital sender from use until the reset is complete
●erases the configuration for TCP/IP, DNS/WINS, security,
●erases the contents of all public and personal address books, distribution lists, and phone books.
Notes about the procedure:
●After you reset the digital sender to the factory defaults, neither you nor any users can use the digital sender again until you have reconfigured it, starting with the steps under “Configure
CAUTION | This action cannot be undone. |