HP L65500 manual Move the printer

Page 33

3.Lift up the right-hand side of the filter container; it pivots on the left.

4.Pull the old filter out of the bottom of its container and dispose of it according to the instructions provided with the new filter.

5.Unpack the new filters and ensure that the blue tabs at each end of each filter are at right angles to the filter.

6.Insert the new filter into the container.

7.Ensure that the blue tabs on the filters are correctly engaged with the hooks on the containers, otherwise the containers may not close completely.

8.Lower the container into position.

9.Lower the carriage cover and close the door. Press the OK key on the front panel.

10.If you forgot to select Replace cleaner roll before replacing the printhead cleaning roll, you should

now go to the front panel and select Check cleaner roll from the Ink System menu .

Move the printer

If you wish to move the printer a short distance on the same site, across a horizontal floor with no steps and no slopes of more than 5% inclination, see the following instructions. For more difficult movement operations, please call your service representative (see HP Customer Care Centers on page 49).

CAUTION: Slopes steeper than 5% may cause serious damage to the printer.

1.Turn off the printer.

2.Disconnect all power and network cables from the printer.

3.Disconnect all ink cartridges and remove them from the printer. Hold the cartridge connectors in position with adhesive tape.

Hardware maintenance

ENWW	Move the printer 27

Image 33

Contents HP Designjet L65500 Printer Trademarks Table of contents Software maintenance Front-panel error messages When you need help Enww General safety guidelines Safety precautionsFire hazard Label Explanation Identifies the main earth terminal Emergency stop buttons Printer status Check printer statusPrinter alerts Align the printheads Printer calibrationTroubleshoot printhead alignment Substrate-advance compensationColor calibration Color calibration Color profiles Ink restrictionsMaintain the ink cartridges Hardware maintenanceMaintain the printheads Maintain the substratesCheck the printheads Clean the carriage coverClean the carriage rails Hardware maintenance Clean the ink deposits Clean the exterior of the printerClean the line sensor and aerosol inlets Clean the substrate edge holders Clean the main rollerClean the platen Clean the pinch wheelsClean the printheads Clean the substrate-advance sensorClean the temperature sensors Maintain the printhead primers Replace the carriage oiler foams Hardware maintenance Replace the line sensor box Replace the printhead cleaning roll Replace the printhead cleaning roll and aerosol filtersReplace the printhead cleaning roll and aerosol filters Replace the aerosol filters Move the printer Cleaning kit Printer maintenance kitsMaintain the HP Internal Print Server Software maintenanceUpdate the firmware Troubleshoot substrate issues Substrate cannot be loaded successfullySubstrate has jammed Substrate is not attached to the input core Ink is still wet when the substrate emerges Substrate sticks to the platenThere are ink marks on the substrate Troubleshoot print-quality issues General adviceBanding Banding Colors are misaligned vertically Colors are misalignedColors are misaligned horizontally Print is grainySubstrate is not flat Print is smudgedEdges of objects are rough or blurred Colors look washed outColors are inaccurate Cannot insert an ink cartridge Troubleshoot ink cartridge and printhead issuesCannot insert a printhead Front panel recommends replacing or reseating a printheadIncorrect printhead cleaning roll errors Printhead has overheatedPrinthead has damaged the substrate Printer does not print Troubleshoot other issuesPrinter seems slow HP Internal Print Server cannot detect the printerUpgrade the HP Internal Print Server Print job files have not been properly deletedColor calibration fails Front-panel errors Front-panel error messages2Numerical error codes Icon, then Carriage beam position Carriage system recovery Correctly inflated. The substrate will be unloaded Documentation When you need helpHP Proactive Support HP Customer CareHP Customer Care Centers Service information Preset creation flowchart Index Enww