HP L65500 manual Replace the carriage oiler foams

Page 27

Replace the carriage oiler foams

The printhead carriage contains two chunks of foam impregnated with oil that continuously lubricate the carriage rails. They may need to be replaced about every two or three months, depending on your use of the printer. Replacement foams are available in the Cleaning Kit.

1.Go to the front panel and select Replace oiler foam from the Preventive Maintenance menu . The carriage moves into the electrical compartment.

2.Open the printhead access door.

3.Slide off the cover of the left oiler foam.

4.Remove the old foam, insert the new foam, and replace the cover.

Hardware maintenance

ENWW	Replace the carriage oiler foams 21

Image 27

Contents HP Designjet L65500 Printer Trademarks Table of contents Software maintenance Front-panel error messages When you need help Enww General safety guidelines Safety precautionsFire hazard Label Explanation Identifies the main earth terminal Emergency stop buttons Printer status Check printer statusPrinter alerts Align the printheads Printer calibrationTroubleshoot printhead alignment Substrate-advance compensationColor calibration Color calibration Color profiles Ink restrictionsMaintain the substrates Hardware maintenanceMaintain the ink cartridges Maintain the printheadsCheck the printheads Clean the carriage coverClean the carriage rails Hardware maintenance Clean the ink deposits Clean the exterior of the printerClean the line sensor and aerosol inlets Clean the substrate edge holders Clean the main rollerClean the substrate-advance sensor Clean the pinch wheelsClean the platen Clean the printheadsClean the temperature sensors Maintain the printhead primers Replace the carriage oiler foams Hardware maintenance Replace the line sensor box Replace the printhead cleaning roll Replace the printhead cleaning roll and aerosol filtersReplace the printhead cleaning roll and aerosol filters Replace the aerosol filters Move the printer Cleaning kit Printer maintenance kitsMaintain the HP Internal Print Server Software maintenanceUpdate the firmware Troubleshoot substrate issues Substrate cannot be loaded successfullySubstrate has jammed Substrate is not attached to the input core Ink is still wet when the substrate emerges Substrate sticks to the platenThere are ink marks on the substrate Troubleshoot print-quality issues General adviceBanding Banding Colors are misaligned vertically Colors are misalignedColors are misaligned horizontally Print is grainyColors look washed out Print is smudgedSubstrate is not flat Edges of objects are rough or blurredColors are inaccurate Front panel recommends replacing or reseating a printhead Troubleshoot ink cartridge and printhead issuesCannot insert an ink cartridge Cannot insert a printheadIncorrect printhead cleaning roll errors Printhead has overheatedPrinthead has damaged the substrate HP Internal Print Server cannot detect the printer Troubleshoot other issuesPrinter does not print Printer seems slowUpgrade the HP Internal Print Server Print job files have not been properly deletedColor calibration fails Front-panel errors Front-panel error messages2Numerical error codes Icon, then Carriage beam position Carriage system recovery Correctly inflated. The substrate will be unloaded HP Customer Care When you need helpDocumentation HP Proactive SupportHP Customer Care Centers Service information Preset creation flowchart Index Enww