HP L65500 manual Colors are inaccurate

Page 45

Colors are inaccurate

1.Check that the substrate has been correctly loaded.

2.Check that the loaded substrate is the same as the substrate selected in the HP Internal Print Server.

3.Check that the ICC profile used by the RIP is correct for the loaded substrate.

Print-quality issues

ENWW	Colors are inaccurate 39

Image 45

Contents HP Designjet L65500 Printer Trademarks Table of contents Software maintenance Front-panel error messages When you need help Enww General safety guidelines Safety precautionsFire hazard Label Explanation Identifies the main earth terminal Emergency stop buttons Printer status Check printer statusPrinter alerts Align the printheads Printer calibrationTroubleshoot printhead alignment Substrate-advance compensationColor calibration Color calibration Color profiles Ink restrictionsMaintain the ink cartridges Hardware maintenanceMaintain the printheads Maintain the substratesCheck the printheads Clean the carriage coverClean the carriage rails Hardware maintenance Clean the ink deposits Clean the exterior of the printerClean the line sensor and aerosol inlets Clean the substrate edge holders Clean the main rollerClean the platen Clean the pinch wheelsClean the printheads Clean the substrate-advance sensorClean the temperature sensors Maintain the printhead primers Replace the carriage oiler foams Hardware maintenance Replace the line sensor box Replace the printhead cleaning roll Replace the printhead cleaning roll and aerosol filtersReplace the printhead cleaning roll and aerosol filters Replace the aerosol filters Move the printer Cleaning kit Printer maintenance kitsMaintain the HP Internal Print Server Software maintenanceUpdate the firmware Troubleshoot substrate issues Substrate cannot be loaded successfullySubstrate has jammed Substrate is not attached to the input core Ink is still wet when the substrate emerges Substrate sticks to the platenThere are ink marks on the substrate Troubleshoot print-quality issues General adviceBanding Banding Colors are misaligned vertically Colors are misalignedColors are misaligned horizontally Print is grainySubstrate is not flat Print is smudgedEdges of objects are rough or blurred Colors look washed outColors are inaccurate Cannot insert an ink cartridge Troubleshoot ink cartridge and printhead issuesCannot insert a printhead Front panel recommends replacing or reseating a printheadIncorrect printhead cleaning roll errors Printhead has overheatedPrinthead has damaged the substrate Printer does not print Troubleshoot other issuesPrinter seems slow HP Internal Print Server cannot detect the printerUpgrade the HP Internal Print Server Print job files have not been properly deletedColor calibration fails Front-panel errors Front-panel error messages2Numerical error codes Icon, then Carriage beam position Carriage system recovery Correctly inflated. The substrate will be unloaded Documentation When you need helpHP Proactive Support HP Customer CareHP Customer Care Centers Service information Preset creation flowchart Index Enww