Home Automation SECURITY SYSTEM owner manual Latitude, Longitude, and Time Zone, Zone Name

12:00 AM MTWTFSS #=CHNG

TIME CLOCK 1 OFF TIME

--NEVER #=CHNG

For example, it may be desirable to conditionalize certain programs to execute only during a normal Monday - Friday 9:00 AM - 5:00 PM work week.

The default for Time Clock 1 ON is 12:00 AM MTWTFSS, and the default for Time Clock 1 OFF is Never, so that Time Clock 1 is always Enabled.

TIME CLOCK 2 ON

TIME CLOCK 2 OFF

TIME CLOCK 3 ON

TIME CLOCK 3 OFF

Time Clocks 2 and 3 is entered into the system and set for time and dates exactly like the settings for Time Clock 1.

Latitude, Longitude, and Time Zone

The system automatically calculates the time of sunrise and sunset each day. Sunrise/sunset can be specified as the time a scheduling command is executed, as an enable/disable time, or as a darkness condition on a scheduling command or event button.

To enable the system to properly calculate sunrise and sunset times, you must enter your latitude, location north or south of the equator, longitude, location east or west of the Prime Meridian, and time zone.

These items should be set to the proper values for the location where the OmniLT is installed. The latitude and longitude for a particular location may be obtained from an almanac or map of the area. These values should be entered to the nearest degree.

The value entered for the time zone is the number of hours difference between local standard time at the OmniLT location and Greenwich Mean Time. The following values should be used for the standard time zones in North America:

ZONE NAME

4ATLANTIC

5EASTERN

6CENTRAL

7MOUNTAIN

8PACIFIC

9YUKON

10ALASKA-HAWAII

11BERING

The value specified for longitude may be adjusted to correct for areas, such as Nova Scotia, where the local time differs from Greenwich Mean Time by a non-hourly amount. The calculated time of sunrise/sunset will change by four minutes for every degree change in longitude. To cause the calculated sunrise/sunset to occur later, enter a larger value for longitude. Enter a smaller value for longitude to cause the time to occur earlier.

It is not necessary to alter the time zone to compensate for daylight savings time, OmniLT will automatically adjust its calculations for sunrise and sunset, and time when daylight savings time begins and ends.

LATITUDE:	30
0-60
LATITUDE N/S:	1
1=NORTH 2=SOUTH
LONGITUDE:	90
0-180
LONGITUDE E/W:	2
1=EAST 2=WEST

65