Desa GCP10TGCN20T, GCP20T Placing Heater On Mounting Bracket, Installing Bottom Mounting Screws

Page 11
Placing Heater On Mounting Bracket

INSTALLATION

Installing Heater To Wall 20,000 Btu/Hr Models (5.9 kW) (Cont.) Mounting Heater To Floor With Optional Floor Kit [20,000 Btu/Hr (5.9 kW) Only]

11

INSTALLATION

Continued

Placing Heater On Mounting Bracket

1.Locate two horizontal slots on back panel of heater.

2.Place heater onto mounting bracket. Slide horizontal slots onto stand-out tabs on mounting bracket.

Horizontal Slots

Stand-Out Tab

 

Mounting Bracket

 

 

(attached to wall)

 

 

 

 

 

Figure 18 - Mounting Heater Onto Mounting Bracket

Installing Bottom Mounting Screws

1.Locate two bottom mounting holes. These holes are near bot- tom on back panel of heater (see Figure 19).

2.Mark screw locations on wall.

3.Remove heater from mounting bracket.

4.If installing bottom mounting screws into hollow or solid wall, install wall anchors. Follow steps 1 through 4 under Attaching To Wall Anchor Method, page 10.

If installing bottom mounting screw into wall stud, drill holes at marked locations using 9/64" drill bit.

5.Replace heater onto mounting bracket.

6.Place spacers between bottom mounting holes and wall anchor or drilled hole.

7.Hold spacer in place with one hand. With other hand, insert mounting screw through bottom mounting hole and spacer. Place tip of screw in opening of wall anchor or drilled hole.

8.Tighten both screws until heater is firmly secured to wall. Do not over tighten.

Note: Do not replace front panel at this time. Replace front panel after making gas connections and checking for leaks (see

pages 11 and 12).

Heater

Wall

Spacer

Front View

Side View

 

Figure 19 - Installing Bottom Mounting Screws

MOUNTING HEATER TO FLOOR WITH OPTIONAL FLOOR KIT [20,000 BTU/HR (5.9 KW) ONLY]

Mounting Base Feet to Heater

1.Lay heater cabinet on its back on a table with the heater bot- tom overhanging the table edge.

2.Align holes in base foot with mounting holes on bottom of cabinet (see Figure 20).

3.Secure base foot to heater using sheet metal screws.

4.Repeat for other side.

Mounting Base Feet to Floor (Where required by local code)

If heater is being installed directly on carpeting, tile or other combustible material (other than wood flooring), the heater shall be installed on a metal or wood panel extending the full width and depth of the appliance.

1.Remove front cover (see Removing Front Panel of Heater, page 10).

2.Position heater with base feet in desired location. Mark holes for drilling. Remove heater with base.

3.If mounting base to a wood floor, drill 1/8 inch diameter hole, 3/4 inch (2 cm) deep. (Do not use anchors in wood floors).

If mounting base to a concrete floor, drill with 1/4 inch diam- eter concrete drill bit, 13/8 inches (3.5 cm) into floor. Insert anchors completely into holes.

4.Reposition heater with base feet over holes. Secure base to floor with wood screws. See Figure 20.

Wood

Screw

Installing Bottom Mounting ScrewsMounting Base Feet to HeaterManual backgroundManual background Base Foot Sheet Metal ScrewManual backgroundManual backgroundManual background

Figure 20 - Installing Base Feet (Heater may vary from illustration)

Manual backgroundManual backgroundManual backgroundManual backgroundFor more information, visit www.desatech.com

112157-01A

Page 10 Page 12
Image 11
Page 10 Page 12
Contents Do not try to light any appliance GCN20T, GCP20TGCN6, GCP6 WHAT TO DO IF YOU SMELL GASWARNINGS TABLE OF CONTENTSSAFETY INFORMATION PRODUCT IDENTIFICATION PRODUCT FEATURESSAFETY DEVICE UNPACKINGUnusually Tight Construction LOCAL CODESAIR FOR COMBUSTION AND VENTILATION PROVIDING ADEQUATE VENTILATIONAIR FOR COMBUSTION AND VENTILATION DETERMINING FRESH-AIRFLOW FOR HEATER LOCATIONAIR FOR COMBUSTION AND VENTILATION ContinuedVentilation Air From Inside Building INSTALLATIONVENTILATION AIR CHECK GAS TYPEContinued INSTALLATION ITEMSLOCATING HEATER INSTALLATIONTHERMOSTAT SENSING BULB Thermostat Models Only Installing Two Mounting ScrewsAttaching Thermostat Sensing Bulb Marking Screw LocationsMounting Bracket Installing Bottom Mounting ScrewPlacing Heater On Mounting Screws Removing Front Panel Of HeaterContinued Methods For Attaching Mounting Bracket To WallAttaching Mounting Bracket To Wall INSTALLATIONINSTALLATION Installing Bottom Mounting ScrewsPlacing Heater On Mounting Bracket Mounting Base Feet to HeaterContinued CONNECTING TO GAS SUPPLYINSTALLATION INSTALLATIONINSTALLATION Pressure Testing Gas Supply Piping SystemPressure Testing Heater Gas Connections CHECKING GAS CONNECTIONSLIGHTING INSTRUCTIONS FOR YOUR SAFETY READ BEFORE LIGHTINGOPERATING HEATER THERMOSTAT CONTROL OPERATION THERMOSTAT MANUAL LIGHTING PROCEDUREINSPECTING BURNER TO TURN OFF GAS TO APPLIANCEBURNER PILOT AIR INLET HOLE CLEANING AND MAINTENANCECABINET ODS/PILOT AND BURNER ORIFICEREMEDY TROUBLESHOOTINGOBSERVED PROBLEM POSSIBLE CAUSEContinued Maintenance, pageTROUBLESHOOTING OBSERVED PROBLEMOBSERVED PROBLEM ing Gas Connections, page1. Refer to Fresh Air for Combustion and TROUBLESHOOTINGILLUSTRATED PARTS BREAKDOWN ILLUSTRATED PARTS BREAKDOWNMANUAL CONTROL MODELS GCP6 AND GCN6 PILOTGCP6 PARTS LISTPARTS LIST PART NUMBERPILOT THERMOSTAT CONTROLLED MODELSGCP10T GCN10T ILLUSTRATED PARTS BREAKDOWNGCP10T PARTS LISTPARTS LIST PART NUMBERILLUSTRATED PARTS BREAKDOWN THERMOSTAT CONTROLLEDMODELS GCN20T AND GCP20TGCN20T PARTS LISTPARTS LIST PART NUMBERGCP10T SPECIFICATIONSSERVICE CENTER/PARTS CENTRAL GCP6OWNERS REGISTRATION FORM TAPE Postage RequiredTAPE 2701 Industrial Drive P.O. Box Bowling Green, KYSERVICE HINTS REPLACEMENT PARTSSERVICE PUBLICATIONS ACCESSORIESModel Serial No Date Purchased WARRANTY INFORMATIONLIMITED WARRANTY VENT-FREERESIDENTIAL GAS HEATERS email desacan@sympatico.caET MODE D’EMPLOI RADIATEUR À GAZ À FLAMME BLEUE SANS CONDUITD’ÉVACUATION INFORMATIONS RELATIVES À LA SÉCURITÉAVERTISSEMENTS TABLE DES MATIÈRESINFORMATIONS RELATIVES À LA SÉCURITÉ Suite DÉBALLAGEIDENTIFICATION DU PRODUIT CARACTÉRISTIQUES DU PRODUITConstruction particuliè rement é tanche CODES LOCAUXAIR POUR LA COMBUSTION ET LA VENTILATION POUR FOURNIR UNE VENTILATION ADÉ QUATEque l’espace peut supporter OU AIR POUR LA COMBUSTION ET LA VENTILATIONSuite Air de ventilation de l’exté rieur AIR DE VENTILATIONVÉ RIFIEZ LE TYPE DE GAZ Air de ventilation de l’inté rieur du bâ timentAVERTISSEMENT Ne jamais installer le radiateur ARTICLES POUR L’INSTALLATIONPLACEMENT DU RADIATEUR INSTALLATIONmodè les à thermostat uniquement Marquage de l’emplacement des visInstallation des deux vis de montage BULBE THERMOSTATIQUESupport de montage Placement du radiateur sur les vis de montageInstallation de la vis de montage infé rieure Retrait du panneau avant du radiateurSuite Fixation du support de montage au murINSTALLATION Marquage de l’emplacement des visMontage des pieds au sol si le code local l’exige Placement du radiateur sur le support de montageInstallation des vis de montage infé rieures Montage des pieds sur le radiateurSuite RACCORDEMENT À L’ALIMENTATION EN GAZINSTALLATION Suite VÉ RIFICATION DES CONNEXIONS AU GAZINSTALLATION INSTRUCTIONS D’ ALLUMAGE UTILISATION DU RADIATEURPOUR VOTRE SÉ CURITÉ - À LIRE AVANT L’ALLUMAGE PAR THERMOSTAT MODÈ LES À THERMOSTAT UNIQUEMENT INSPECTION DU BRÛLEURPOUR COUPER LE GAZ DE L’APPAREIL UTILISATION DU CONTRÔ LEConduits d’air NETTOYAGE ET ENTRETIENODS/VEILLEUSE ET ORIFICE DU BRÛ LEUR HABILLAGECAUSE POSSIBLE SOLUTIONDÉPANNAGE SYMPTÔ MESYMPTÔ ME SOLUTIONDÉPANNAGE SuiteSYMPTÔ ME SOLUTIONDÉPANNAGE SuiteVUE DÉTAILLÉE DU RADIATEUR VUE DÉTAILLÉE DU RADIATEURMODÈ LES À CONTRÔ LE MANUEL GCP6 ET GCN6 VEILLEUSEGCP6 LISTE DES PIÈCESLISTE DES PIÈCES NUMÉ RO DE PIÈ CEVEILLEUSE MODÈ LES CONTRÔ LÉ S PAR THERMOSTATGCP10T ET GCN10T VUE DÉTAILLÉE DU RADIATEURGCP10T LISTE DES PIÈCESLISTE DES PIÈCES NUMÉ RO DE PIÈ CEVUE DÉTAILLÉE DU RADIATEUR MODÈ LES CONTRÔ LÉ S PARTHERMOSTAT GCN20T ET GCP210TGCN20T LISTE DES PIÈCESLISTE DES PIÈCES NUMÉ RO DE PIÈ CESPÉCIFICATIONS CENTRE DE SERVICE/DÉPÔT DE PIÈCESPage 2701 Industrial Drive P.O. Box Bowling Green, KY Affran chissement RequisRUBAN RUBANSERVICE TECHNIQUE PUBLICATIONS POUR LE SERVICEACCESSOIRES CONSEILS DE SERVICE2220, Argentia Road, Unité 4 Mississauga, Ontario INFORMATION SUR LA GARANTIEGARANTIE LIMITÉE NOT A UPC
Top Page Image Contents