PRODUCT FEATURES AND CODE APPROVAL
PRODUCT SPECIFICATIONS
•This appliance has been certi- fied for use with either natural or propane gas. See appropriate data plates.
•This appliance is not for use with solid fuels.
•The appliance is approved for bedroom or bedsitting room installations.
•The appliance must be installed in accordance with local codes if any. If none exist use the current installation code. ANSI Z223.1/ NFPA 54 in the USA, CAN/CGA B149 in Canada.
•This appliance is mobile home approved.
•The appliance must be properly connected to a venting system.
•The appliance is not approved for closet or recessed installations.
The efficiency rating of this appli- ance is a product thermal efficiency rating determined under continuous operating conditions and was deter- mined independently of any installed system.
Thermal efficiency up to 75% AFUE efficiency up to 71%
CODE APPROVAL
Hi/Lo Knob
Off/Pilot/On Knob |
|
On/Off/RS Switch |
|
Ignitor |
|
Blower Control | Optional Remote |
Receiver |
Figure 1 - HBDV300 and HBDV400 Fireplace
Direct Vent type appliances draw all combustion air from outside of the dwelling through the vent pipe.
These appliances have been tested by CSA and found to comply with the established standards for DIRECT VENT GAS FIREPLACE HEATERS in the USA and Canada as follows:
LISTED VENTED GAS FIREPLACE HEATER
TESTED TO: ANSI Z21.88-2007/CSA 2.33-2007 STANDARDS
A manufactured home (USA only) or mobile home OEM installation must conform with the Manufactured Home Con- struction and Safety Standard, Title 24 CFR, Part 3280, or when such a standard is not applicable, the Standard for Manufactured Home Installations, ANSI/NCSBCS A225.1, or Standard for Gas Equipped Recreational Vehicles and Mobile Housing, CSA Z240.4.
54D5031 | 5 |