FINAL INSTALLATION
Log #3
Log #2
Figure 48 - Placement of Log 2 | Figure 49 - Placement of Log 3 |
6a. For 400 models, place log #3 into place by matching the notch on the side of the log with the protrusion on the rear log. Set the left side of the log over the cross bar of grate by placing the notch of the log on the grate bar. Be sure the log is tilted backward. When this log is in place, it is seated sideways. See Figure 49.
6b. For 300 models, place log #3 into place by matching the notch on the side of the log with the protrusion on the rear log. Set the left side of the log over the grate bar in the front by placing the notch of the log on the grate bar. Make sure the log is tilted backward. When this log is in place, it is seated sideways. See Figure 49.
Log #4
Log #5
Figure 50 - Placement of Log 4 | Figure 51 - Placement of Log 5 |
7.Place log #4 into place by matching the two notches on the bottom of this log with the two protrusions on log #1&2. This log, when seated, fits in the middle above logs 1 & 2. See Figure 50.
8.Place log #5 into place by matching the two notches on the bottom of this log with the two protrusions on log #1&2. This log, when seated, is positioned toward the right. See Figure 51.
9a. For 400 models, place log #6 into place toward the left by sitting the notch on this log on the left tong of the grate and set the tips of the log on the burner in front the large round holes. See Figure 52.
9b. For 300 models, place log #6 into place toward the left by sitting the notch on this log on the left tong of the grate and set the tips of the log on the burner. See Figure 52.
10.For 400 models only, place log #7 into place by hooking the end of the log on the second right tong of the grate and resting the other end over the lava rock. See Figure 53. (There is no seventh log on 300 models.)
11.Adjust the screws and set the andirons over the cross bar of the grate between the two outer tongs on the right and left sides of the grate.
34 | 54D5031 |