Monessen Hearth Understanding the TSFSC Remote for Enhanced Control of Your Fireplace

SIGNATURE COMMAND SYSTEM OPERATION INSTRUCTIONCDVSC7 & CDV7 Series Gas Fireplace

FEATURES

Command Center

•Easy Access Function Operation and System Configuration

•Operation Confirmation/Fault Diagnostic Indications (LED/ Buzzer)

•ON/OFF/HI/Med/Low Operation

•Optional Wall Mounting

Control Board

•Electronic Ignition

•Pilot Lockout safety feature

•Electric Power Regeneration from Thermopile to save bat- tery

•6-hour Automatic Shut Down Option

•Convenient NG/LP Gas Type Conversion

•Standing Pilot/Intermittent pilot Conversion

•Previous settings Restoration Ability (Memory Off)

•Uninterrupted Operation During Power Outage (Automatic Battery Backup)

•ON/OFF RF Remote Receiver

•Optional Transmitter Learn Capability

AC Module Board (Optional, requires TSFSC Remote)

•Easy Snap-on Design

•Embedded Compact 120 VAC Adapter with Auto Battery Back up Feature

RF Receiver	To Thermopile
ON/OFF	To Sensor

To Sparker

NG/LP

Conversion

Control
Board	To Command Center

To Stepper Motor

To Valve

OFF

LED

ON

Master Switch

Command

Center

Battery Door

Figure 60 -

Signature Command System Components

•Remote Controlled 3-step Blower, Lighting, and On/Off Auxiliary AC Outputs

Transmitter (Optional)

TSFSC		TSTSC	TSMSC	RTSC	RMSC
Three Flame Height Settings	X	X	X	X	X
Low battery Indication for Transmitter	X	X	X	X	X
Child Proof Lock-out	X	X	X	X	X
LCD Backlight	X	X	X	X	X
Security Codes 16	X	X	X	X	X
Countdown 6 hr Timer	X	X	X	--	--
Standard Thermostatic Control Mode	X	X	--	X	--
Smart Mode Thermostat (Auto Flame & Blower Modulation)	X	X	--	--	--
Three Brightness Settings for Lights	X	--	--	--	--
Three Speed Control for Blower	X	--	--	--	--
On/Off Auxiliary	X	--	--	--	--
Programmable Timer to turn blower on and off	X	--	--	--	--

BATTERY INSTALLATION

The Command Center uses four (4) "AA" batteries as back up for power outages. The system can operate for ap- proximately six (6) months on battery power.

To Install Batteries (not included):

1.Press down the battery door tabs and pull out to remove battery door.

2.Install the batteries as indicated on Command Center.

3.Close battery door by snapping in place.

4.When the four (4) batteries are installed the system will operate without power.

5.The batteries should be replaced when the LED indicates low battery or at least once a year.

69D3011 43