Monessen Hearth CDV7 manual Glass Frame Removal, Rock wool placement

CDVSC7 & CDV7 Series Gas Fireplace glass removal & ROCK WOOL PLACEMENT

Glass Frame Removal

1. Remove upper and lower louvers.

2. Release the clamps on the bottom of the fireplace. Figure 61

3. Tilt glass frame out and lift glass frame up until it clears the hook on top of the frame.

4. Set glass frame aside.

Glass Frame

CAUTION	Each clamp has a quick spring force. When
	reinstalling clamps, keep fingers clear.

! WARNING

HOT GLASS WILL

CAUSE BURNS.

DO NOT TOUCH GLASS

UNTIL COOLED.

NEVER ALLOW CHILDREN

TO TOUCH GLASS.

rock wool placement

Clamps -

2 on 33/36 Models,

3 on 42/47 Models

Figure 61 -	FP2297
Removing Glass Frame - CDVR Series Shown

Burner

1.For best results in flame appearance and opera- tion, use one (1) 8 gram bag of rock wool for propane/LP models and up to three (3) bags of rock wool for natural gas models.

2.Pull the rock wool apart into dime-sized pieces or smaller. Cover the entire surface of the burner with one thin layer of rock wool.

3.Place the logs on the burner. Refer to the “Log Placement Section”. Light the unit and after 15 minutes check burner flame and glow. Adjust embers as necessary to achieve an even and clean flame.

Cover with	FP2648
Rock Wool

Figure 62 - Placement of Rock

Wool on Burner

WARNING

The use of too much rock wool could cause flame to burn poorly and may cause sooting.

46 69D3011