Jotul Woodstove F 400 Stove-Top Thermometer #, Outside Air Kit #154335, Floor Bracket Kit #750304

Page 13

Warning: Operate your Jøtul F 400 with the front door fully open and the firescreen in place or fully closed. A partially opened door may result in overfiring. Also, if the door are left partly open, gas and flame may be drawn out of the stove opening, creating risks from both fire and smoke.

Stove-Top Thermometer (# 5002)

Jøtul recommends the use of a magnetic stove-top thermometer to monitor the surface temperature of the stove. The optimum surface temperature range for the most efficient, clean burn is between 400° and 600°.

Outside Air Kit (#154335)

Your local building code may require that an outside air supply be connected to the stove. Jøtul Outside Air Kit 154335 must be used in these installations unless otherwise specified by the local code official.While the use of outside air may be beneficial in some installations, in itself, such a system does not guarantee proper chimney performance. The Outside Air Kit includes an adapter collar to attach the air duct to the stove. Installation will require these additional materials not included in the kit:

1.3” (80 mm) diameter flexible metallic Air Duct - of appropriate length to reach from the stove to the outside of the house.

2.Weatherproof Duct Cap for the duct termination on the outside of the house.

3.Rodent Screen - no larger than 1/4” (5 mm) mesh.

Outside air should be considered if:

1.The stove does not “draw”steadily. Smoke rollout occurs when the door are opened. Fuel burns poorly. Backdrafts occur with or without a fire burning.

2.Other fuel-fired equipment in the house, such as fireplaces or other heating appliances, smell, do not operate properly, suffer smoke roll-out when opened, or back-draft whether or not there is combustion present.

3.Opening a window slightly on a calm (windless) day alleviates any of the above symptoms.

4.The house is equipped with a well-sealed vapor barrier and tight fitting windows and/or has any powered devices that exhaust house air.

5.There is excessive condensation on the windows in the winter.

6.A ventilation system is installed in the house.

If these or other indications suggest that infiltration air is inadequate to supply sufficient air for the stove, additional combustion air should be provided from the outdoor. Outside combustion air can be provided to the appliance by the following means:

1.Direct connection: The Jøtul F 400 has been tested and approved for use with the outside air kit listed above.

2.Indirect method: Outside air is ducted to a point no closer than (12”) 300 mm from the stove, to avoid affecting

USA/Canada

the performance of the appliance.

3.A mechanical ventilation system: If the house has a ventilation system (air change or heat recovery):

a.The ventilation system may be able to provide sufficient combustion makeup air for the solid-fuel appliance.

b.The homeowner should be informed that the ventilation system might need to be rebalanced by a ventilation technician after installation of the appliance.

Note: Provision of outside air to the stove, directly or indireclty, may fail to remedy the problems outlined above. Chimney performance is determined by a variety of interelating factors which may not be affected by the air supply. Your local Jøtul authorized dealer is your best resource for information regarding chimney and stove performance issues.

Floor Bracket Kit (#750304)

Use of the Floor Bracket Kit is required in all mobile home installations to secure the stove to the floor. Complete installation instructions and diagrams are supplied with each Floor Bracket Kit.

Rear Heat Shield (# 154385)

A stove rear heat shield has been specifically designed for the Jøtul F 400 to reduce clearances off the rear of the stove to combustible materials. Use of the heat shield does not affect the clearance off the sides of the appliance. See pages 8-9 for specific clearance requirements. Complete installation instructions are supplied with the heat shield.

No other type of heat shield may be used on the rear of the Jøtul F 400 .

Bottom Heat Shield (# 154384)

The bottom heat shield supplied with your stove has been specifically designed for the Jøtul F 400 . It is required in all alcove installations. Use of the bottom heat shield does not affect the floor protection requirements described on page 6 of this manual.

No other type of heat shield may be used on the bottom of the Jøtul F 400 .

13

Image 13
Contents Jøtul F Check Building Codes StandardsInstallation Safety NoticesTable of Contents Chimney Requirements Assembly Before InstallationMasonry Chimneys Chimney Height Prefabricated ChimneysWall Pass-Throughs Masonry Chimney Clearance to CombustiblesHearthmount into a Masonry Fireplace Clearances to Walls and CeilingsAlcove Installation Using Shields to Reduce ClearancesMobile Home Installation Jøtul F 400 Woodstove Clearances Corner InstallationUnprotected Surface Parallel to the WallSide Rear Corner PER NFPA211 or CAN/CSA -B365-M93Operation Break-In ProcedureUse Solid Wood Fuel Only Controls on the Jøtul FAdding Fuel MaintenanceAsh Removal Glass CareAccessories General MaintenanceOutside Air Kit #154335 Stove-Top Thermometer #Floor Bracket Kit #750304 Rear Heat Shield #25 3/4 23 1/4 29 1/2 top exit 25 1/2 rear exit 28 1/2 26 1/2 USA/Canada Draw. no USA/Canada Consult your dealer for part numbers and replacement parts Parts list for the Jøtul F 400 woodstoveAppendix a Alternate floor protectionPage Norsk Innhold Forhold til myndigheteneInstallasjon av Jøtul F Montering av røykrør Kontroll av funksjoner figTilslutning til skorstein Vedlikehold BruksanvisningEkstrautstyr ServicearbeiderSvenska Säkerhetsregler InnehållInstallation av Jøtul F Montering av rökrör Kontroll av funktionerAnslutning till skorsten Första gångs upptändning och dagligt användandeUnderhåll Extrautrustning/tillbehör ServicearbetenPre-installation checks Table of contentsRelationship to the authorities Installation of Jøtul F Control of functions fig Assembly prior to installationMounting of flue pipe Connection to chimneyCleaning and soot removal Cleaning the glassOperating instructions Initial lighting and daily useOptional equipment ServiceTable des matieres Réglementations nationalesInstallation du poêle Jøtul F400 Mise en service Mise en service et usage courantMontage du tuyau de raccordement Raccordement à la cheminéeEntretien Revision Accessoires optionnelsComprobaciones previas a la instalación Índice de contenidoInstalación de Jøtul F Control de funciones fig Montaje previo a la instalaciónInstalación del conducto de humos Conexión a la chimeneaEncendido inicial y uso diario MantenimientoLimpieza del cristal Eliminación de la cenizaConservación Sustitución de la placa deflectora Equipo opcionalIndice generale Conformità alle leggiInstallazione di Jøtul F Montaggio del condotto Controllo delle funzioni figCollegamento alla cappa Prima accensione e utilizzo quotidianoPulizia del vetro ManutenzioneEliminazione della cenere Pulizia del camino ed eliminazione della fuliggineDotazione facoltativa RiparazioneInhalt Behördliche AuflagenAufstellen des Jøtul F Zusammenbau vor der Aufstellung Installation des AbzugsrohrsSteuergeräte Abb Anschluss an den SchornsteinInbetriebnahme und täglicher Gebrauch InbetriebnahmeInbetriebnahme Täglicher GebrauchPflege Austausch der Hitzeschutzplatten InstandhaltungAustausch der Umlenkplatte Wettelijke voorschriften Controle voor de installatieInhoudsopgave Installatie van de Jøtul F Controle van de functies afb GebruiksaanwijzingPlaatsing van de kachelpijp SchoorsteenaansluitingOnderhoud Groot onderhoud Optionele accessoiresPage Page Page Page Qualität KvalitetQuality Qualité

Woodstove F 400 specifications

The Jotul F 400 is a leading model in the Jotul line of woodstoves, renowned for its combination of efficiency, aesthetics, and robust craftsmanship. As one of the company's most popular models, it seamlessly blends functionality with timeless design, making it an ideal choice for both contemporary and traditional spaces.

One of the primary features of the Jotul F 400 is its impressive heating capacity. With an ability to heat spaces of up to 2,000 square feet, this woodstove is perfect for larger rooms or open floor plans. Its firebox can accommodate logs up to 20 inches in length, allowing for longer burn times and fewer refuels. With an average efficiency rating of around 78%, the F 400 ensures that most of the wood's energy is converted into usable heat rather than lost up the chimney.

In terms of design, the Jotul F 400 showcases the classic Norwegian aesthetic that Jotul is known for. Its cast iron construction not only contributes to its durability but also aids in heat retention, ensuring that the stove continues to radiate warmth long after the fire has diminished. The intricate detailing and optional enamel finishes give it an elegant touch, making it a statement piece in any home.

The Jotul F 400 is equipped with advanced combustion technology that promotes a cleaner burn, resulting in reduced emissions. This feature is particularly important in today’s environmentally conscious market, as it aligns with stricter regulations on woodstove emissions. The stove features a secondary combustion system that helps to maximize fuel efficiency while minimizing smoke output, allowing users to enjoy the ambiance of a wood fire without excessive pollutants.

Another notable characteristic of the F 400 is its easy-to-use air control system. This allows users to easily adjust the airflow to the fire, optimizing it for lighting, burning, and maintaining desired temperatures. The large, self-cleaning glass door provides an unobstructed view of the flames, enhancing the ambiance of any room.

In summary, the Jotul F 400 woodstove is a blend of efficiency, beauty, and innovation. Its capacity to heat large spaces, coupled with advanced combustion technology and classic design, makes it one of the top choices for homeowners looking for a reliable and attractive heating solution. Whether for cozy evenings or efficient heating, the Jotul F 400 is sure to enhance any living space.