SoundCraft RK-65K manual Programming Steps

Page 10

Radio Key® RK-65K

Operating Guide

PROGRAMMING STEPS

To program the Radio Key® RK-65K, you must ﬁ rst enter the program mode as described in the next section below. Once in the program mode, the LED will blink amber as an indicator. To take the unit out of program mode you may select an operating mode (seepage14)or simply allow 15 seconds to elapse without presenting a program card to the reader.

After you have completed a proper program sequence, the unit will beep and the LED will ﬂ ash green to indicate that the program instruction has been accepted. A red light and a beep at the end of a programming sequence means that you have made an error. Refer to the appropriate section, and carefully re-enter the command in the proper sequence.

NOTE: User ID Number and ID Number Values in the following examples are for demonstration purposes only; enter the appropriate values for your system.

Secura Key

7

Image 10

Contents With RK100M instructions Stand Alone Proximity Access Control SystemWith Dynascan Technology Copyright Radio Key RK-65K/RK-65KS Operating Guide Introduction Radio Key RK-65KSecura Key Using RK-PD1 or RK-HHP Ordering Transponders Programming Radio KEY RK-65K Programming Radio KEY 100M RK-HHP Handheld Programmer and the RK-PD1 Program Deck Programming Steps To Enter Program Mode RK65K/RK100M Change your Password RK65K/RK100MSetting Facility Codes RK65K Lost or forgotten Password RK65K/RK100M+ 4 + 3 + + 1 + Adding and Deleting Users RK65K Delete a Transponder From The System RK65K Set the Latch Timer RK65K/RK100M Delete a Series Of Transponders From The System RK65KSetting the Latch Timer RK65K/RK100M Programming HintsSet the Operating Mode RK65K/RK100M To Exit Programming Mode Immediately RK65K/RK100M Timed AntipassbackRK65KSet Antipassback Timer RK65K Enable Timed Antipassback RK65KDisable Timed Antipassback RK65K Conﬁgure the Relay RK65K/RK100M Program the Input RK65K/RK100M Basic Operation RK65K/RK100M Secura Key For RK100M mode Secura Key Converting to RK100M ModeFor RK65K mode + 6 + Converting between RK-65K and RK100M modesAdding and Deleting Users Radio KEY 100M ADD Add a Series of Transponders to the System Delete a Transponder from the System Delete a Range of Transponders from System Delete a Transponder by Presenting to ReaderDelete a Transponder by Entering Transponder ID Warranty U.S. and Canadian Specifications Environment OperationalFCC ID NNHRK-100M Instruction to the User