SoundCraft manual Programming Radio KEY RK-65K

Page 7

Radio Key® RK-65K

Operating Guide

PROGRAMMING RADIO KEY® RK-65K

When the RK-65K is ﬁ rst powered up, the LED will be ﬂ ashing Red and Green. Present a card to the unit to set the Facility Code and the ﬂ ashing will end in approximately 10 seconds.

Radio Key Transponders (Key tags and cards) are pre-encoded and engraved at the factory with a Facility (Site) Code and an individual card ID number.

You must teach the RK-65K which Facility Code or Codes (up to 10) it should recognize. You must also enroll the card ID numbers that will be Valid. The Radio Key® cards and tags are sequentially numbered, so you can validate a block of transponders.

Be sure to make a record of each person who is issued a transponder along with the ID number of their card or tag.

Secura Key 4

Image 7

Contents With RK100M instructions Stand Alone Proximity Access Control SystemWith Dynascan Technology Copyright Radio Key RK-65K/RK-65KS Operating Guide Introduction Radio Key RK-65KSecura Key Using RK-PD1 or RK-HHP Ordering Transponders Programming Radio KEY RK-65K Programming Radio KEY 100M RK-HHP Handheld Programmer and the RK-PD1 Program Deck Programming Steps Change your Password RK65K/RK100M To Enter Program Mode RK65K/RK100MSetting Facility Codes RK65K Lost or forgotten Password RK65K/RK100M+ 4 + 3 + + 1 + Adding and Deleting Users RK65K Delete a Transponder From The System RK65K Delete a Series Of Transponders From The System RK65K Set the Latch Timer RK65K/RK100MProgramming Hints Setting the Latch Timer RK65K/RK100MSet the Operating Mode RK65K/RK100M Timed AntipassbackRK65K To Exit Programming Mode Immediately RK65K/RK100MSet Antipassback Timer RK65K Enable Timed Antipassback RK65KDisable Timed Antipassback RK65K Conﬁgure the Relay RK65K/RK100M Program the Input RK65K/RK100M Basic Operation RK65K/RK100M Secura Key Converting between RK-65K and RK100M modes Converting to RK100M ModeFor RK65K mode + 6 + For RK100M mode Secura KeyAdding and Deleting Users Radio KEY 100M ADD Add a Series of Transponders to the System Delete a Transponder from the System Delete a Transponder by Presenting to Reader Delete a Range of Transponders from SystemDelete a Transponder by Entering Transponder ID Warranty U.S. and Canadian Specifications Operational EnvironmentFCC ID NNHRK-100M Instruction to the User