SoundCraft RK-65K manual Adding and Deleting Users RK65K

Page 13

Radio Key® RK-65K

Operating Guide

You can also place a reader in this mode by entering the Program Mode (see page 8) then pressing Mode followed by “9” followed by Enter.

+

9

+

(MODE)

(Mode Number 9) (ENTER)

While the LED is ﬂ ashing Red/Green present one User Card for each Facility Code being used to the reader, one at a time. After you are ﬁ nished, allow the reader to time out and return to the Normal Mode before proceeding. NOTE: An invalid facility code will beep with no LED visible.

ADDING AND DELETING USERS (RK65K)

Add A Transponder (Key Tag or Card) To The System: Place the unit in the Program Mode (See Page 8). Press Add, followed by the sequence of digits representing the Transponder ID number. Then press Enter. For example, to add transponder #12 to the reader the following sequence would be followed:

+

1

+

2

+

(ADD)

(User ID Number 12)

(ENTER)

Transponder number 12 is now valid.

Secura Key 10

Image 13

Contents With RK100M instructions Stand Alone Proximity Access Control SystemWith Dynascan Technology Copyright Radio Key RK-65K/RK-65KS Operating Guide Introduction Radio Key RK-65KSecura Key Using RK-PD1 or RK-HHP Ordering Transponders Programming Radio KEY RK-65K Programming Radio KEY 100M RK-HHP Handheld Programmer and the RK-PD1 Program Deck Programming Steps Change your Password RK65K/RK100M To Enter Program Mode RK65K/RK100MSetting Facility Codes RK65K Lost or forgotten Password RK65K/RK100M+ 4 + 3 + + 1 + Adding and Deleting Users RK65K Delete a Transponder From The System RK65K Delete a Series Of Transponders From The System RK65K Set the Latch Timer RK65K/RK100MProgramming Hints Setting the Latch Timer RK65K/RK100MSet the Operating Mode RK65K/RK100M Timed AntipassbackRK65K To Exit Programming Mode Immediately RK65K/RK100MSet Antipassback Timer RK65K Enable Timed Antipassback RK65KDisable Timed Antipassback RK65K Conﬁgure the Relay RK65K/RK100M Program the Input RK65K/RK100M Basic Operation RK65K/RK100M Secura Key For RK65K mode + 6 + Converting to RK100M ModeFor RK100M mode Secura Key Converting between RK-65K and RK100M modesAdding and Deleting Users Radio KEY 100M ADD Add a Series of Transponders to the System Delete a Transponder from the System Delete a Transponder by Presenting to Reader Delete a Range of Transponders from SystemDelete a Transponder by Entering Transponder ID Warranty U.S. and Canadian Specifications Operational EnvironmentFCC ID NNHRK-100M Instruction to the User