SoundCraft RK-65K manual To Enter Program Mode RK65K/RK100M, Change your Password RK65K/RK100M

Page 11

Radio Key® RK-65K

Operating Guide

To Enter Program Mode (RK65K/RK100M):

Using your programmer, enter your password and then press “ENTER”. (All new units are pre-programmed with the password 12345.) The LED will fl ash amber to show that the unit is in Program Mode. The unit will “time out” and return to Active (Normal) Mode in 15 seconds if no programming follows.

1

+

2

+

3

+

4

+

5

+

(Password)

(ENTER)

NOTE: If fi ve incorrect passwords are entered, the unit will sound an alarm and display a red LED for 30 seconds, then return to normal mode.

Change your Password (RK65K/RK100M):

Put the unit into the Program mode, if necessary (See above). Press THRU. Then enter the sequence of digits representing the desired new password (exactly 5 digits). Then press THRU again. Repeat the new password. Press ENTER. A green light and beep means that the Password was changed. Note that 12345 is the default (factory) password; use another number sequence for best security.

Secura Key 8

Page 10 Page 12
Image 11
Page 10 Page 12
Contents With Dynascan Technology Stand Alone Proximity Access Control SystemWith RK100M instructions Copyright Radio Key RK-65K/RK-65KS Operating Guide Secura Key Radio Key RK-65KIntroduction Using RK-PD1 or RK-HHP Ordering Transponders Programming Radio KEY RK-65K Programming Radio KEY 100M RK-HHP Handheld Programmer and the RK-PD1 Program Deck Programming Steps Change your Password RK65K/RK100M To Enter Program Mode RK65K/RK100M+ 4 + 3 + + 1 + Lost or forgotten Password RK65K/RK100MSetting Facility Codes RK65K Adding and Deleting Users RK65K Delete a Transponder From The System RK65K Delete a Series Of Transponders From The System RK65K Set the Latch Timer RK65K/RK100MProgramming Hints Setting the Latch Timer RK65K/RK100MSet the Operating Mode RK65K/RK100M Timed AntipassbackRK65K To Exit Programming Mode Immediately RK65K/RK100MDisable Timed Antipassback RK65K Enable Timed Antipassback RK65KSet Antipassback Timer RK65K Configure the Relay RK65K/RK100M Program the Input RK65K/RK100M Basic Operation RK65K/RK100M Secura Key Converting between RK-65K and RK100M modes Converting to RK100M ModeFor RK65K mode + 6 + For RK100M mode Secura KeyAdding and Deleting Users Radio KEY 100M ADD Add a Series of Transponders to the System Delete a Transponder from the System Delete a Transponder by Presenting to Reader Delete a Range of Transponders from SystemDelete a Transponder by Entering Transponder ID Warranty U.S. and Canadian Specifications Operational EnvironmentFCC ID NNHRK-100M Instruction to the User
Top Page Image Contents