SoundCraft RK-65K manual Set the Latch Timer RK65K/RK100M

Page 15

Radio Key® RK-65K

Operating Guide

Delete A Series Of Transponders From The System (RK65K):

Place the unit in the Program Mode (see Page 8). Press Void, followed by the sequence of digits representing the lowest transponder ID. Then press Thru followed by the sequence of digits representing the highest number transponder. Finally, press Enter. For example, to delete transponders #1 through #10:

+

1

+

(VOID) (Starting (THRU) User No. 1)

+

1

+

0

+

(Ending User ID

(ENTER)

Number 10)

 

Transponders #1 through #10 are now void.

Set the Latch Timer (RK65K/RK100M):

Put the unit into the Program mode, (See Page 8). Press SET TIMER,thenpressthesequenceofdigitsrepresenting the desired Latch Time (0 - 65535 seconds) to the unit. Press ENTER. A green light and beep means that the Latch Timer setting was changed. (If you set the Latch Timer for “0” seconds, the actual latch time will be approximately 0.25 seconds.) For example, to set the latch timer to 15 seconds, the following sequence would be followed;

+

1

+

5

+

(SET TIMER)

(15 Seconds)

(ENTER)

Secura Key 12

Page 14 Page 16
Image 15
Page 14 Page 16
Contents Stand Alone Proximity Access Control System With RK100M instructionsWith Dynascan Technology Copyright Radio Key RK-65K/RK-65KS Operating Guide Radio Key RK-65K IntroductionSecura Key Using RK-PD1 or RK-HHP Ordering Transponders Programming Radio KEY RK-65K Programming Radio KEY 100M RK-HHP Handheld Programmer and the RK-PD1 Program Deck Programming Steps Change your Password RK65K/RK100M To Enter Program Mode RK65K/RK100MLost or forgotten Password RK65K/RK100M Setting Facility Codes RK65K+ 4 + 3 + + 1 + Adding and Deleting Users RK65K Delete a Transponder From The System RK65K Delete a Series Of Transponders From The System RK65K Set the Latch Timer RK65K/RK100MProgramming Hints Setting the Latch Timer RK65K/RK100MSet the Operating Mode RK65K/RK100M Timed AntipassbackRK65K To Exit Programming Mode Immediately RK65K/RK100MEnable Timed Antipassback RK65K Set Antipassback Timer RK65KDisable Timed Antipassback RK65K Configure the Relay RK65K/RK100M Program the Input RK65K/RK100M Basic Operation RK65K/RK100M Secura Key Converting between RK-65K and RK100M modes Converting to RK100M ModeFor RK65K mode + 6 + For RK100M mode Secura KeyAdding and Deleting Users Radio KEY 100M ADD Add a Series of Transponders to the System Delete a Transponder from the System Delete a Transponder by Presenting to Reader Delete a Range of Transponders from SystemDelete a Transponder by Entering Transponder ID Warranty U.S. and Canadian Specifications Operational EnvironmentFCC ID NNHRK-100M Instruction to the User
Top Page Image Contents