4 Getting Started | Installer Guide |
|
A. Typical Appliance System
NOTICE: Illustrations and photos reflect typical installations and are for design purposes only. Illustrations/diagrams are not drawn to scale. Actual product may vary from pictures in manual
Note: Dual venting configurations ARE NOT allowed. Appliance MUST be vented EITHER vertically OR horizontally.
VERTICAL TERMINATION CAP
(SECTION 10.H)
FLASHING MAINTAINS MINIMUM
CLEARANCE AROUND PIPE
(SECTION 10.H)
HORIZONTAL
TERMINATION CAP
(SECTION 10.H)
WALL PENETRATION 
FRAMING (SECTION 8.B)
STORM COLLAR (SECTION 10.G)
VENT PIPE PENETRATES ROOF PREFERABLY WITHOUT AFFECTING ROOF RAFTERS (SECTION 8.C)
VENT PIPE
(SECTIONS 7 and 8)
CEILING FIRESTOP ON FLOOR OF ATTIC (SECTION 8.C)
FRAMING/HEADER
(SECTION 5)
ATTIC INSULATION SHIELD (NOT SHOWN) MUST BE USED HERE TO KEEP INSULATION AWAY FROM VENT PIPE IF ATTIC IS INSULATED. (SECTION 8.D)
FRAMING HEADED
OFF IN CEILING
JOISTS (SECTION 8.C)
REQUIRED ISOLATION SWITCH: AS5601
LOCATION WITHIN 1 METER OF
FIREPLACE, SUBJECT TO MANTEL
PIECE, ETC. CHECK TO ENSURE IT
REMAINS CLEAR ON ANY MANTEL PIECE
INSTALLATION
OPTIONAL WALL SWITCH
HEATER MUST BE INSTALLED AND
FLUE PENETRATION COMPLETE
PRIOR TO FINISH SHEETING
GAS LINE (SECTION 11)
Figure 4.1 Typical System
Heat & Glo • | 17 |