16 Component Access
WARNING! Risk of Fire, Electric Shock and Burns!
Turn off power to module and valve by unplugging the 6V transformer from the junction cord, before removing fixed glass assembly.
A.Decorative Front and Fixed Glass Assem- bly Removal
•The decorative front can be removed by unscrewing (4) screws that secure the decorative front to the fireplace. Refer to the installation instructions that were included with the decorative front option for more detailed instruction.
•Refer to Section 14.E for fixed glass removal and installation instructions.
B. Valve Pressure Taps
The pressure taps are available through the front of the appliance. The decorative mesh front and fireplace gas assembly must be removed to gain access to the pres- sure taps.
MANIFOLD OUTLET | INLET |
Figure 16.1 Pressure Taps
C. Control Module Access
The control module on this appliance can be accessed by following the following steps:
1.Remove decorative front and fixed glass assembly.
2.Locate the control module. See Figure 16.2.
3.Unplug the black wire from the transformer, unplug the wire harness to the valve, and unplug the orange and white wires from the pilot assembly.
4.Verify the replacement module is installed to the wire diagram listed in Section 12.
| ON/OFF/REMOTE |
GAS VALVE | SWITCH |
CONTROL | DC ADAPTER | BATTERY |
MODULE | PACK |
D. Media Tray Removal
1.Remove decorative front and fixed glass assembly.
2.Remove media tray by removing three screw located on the front edge of the media tray. See Figure 16.3.
REMOVE SCREWS |
Figure 16.3 Remove Media Tray
E. Burner and Base Pan Removal
Once the media tray is removed, the burner assembly and base pan may be removed.
1.Remove burner assembly by removing two screws that secure the burner to the pilot assembly bracket and remove the one screw that secures the burner clip that secures the burner to the base pan. See Figure 16.4.
2.Once the burner is removed, the base pan can be removed by lifting “up” and “out”.
REMOVE SCREWS |
BURNER CLIP |
BASE PAN |
Figure 16.4 Remove Burner Assembly
Figure 16.2 Valve Components
58 | Heat & Glo • |