Top Vent - Vertical Termination
No Elbows
V1 Max= 44 ft. (13.4 m)
Note: If installing a vertical vent/termination off the top of the appliance, the optional exhaust restrictor may be needed.
Note: Use SLP Series |
components only. |
V1 |
Figure 7.5 Vertical Vent Maximum |
Exhaust restrictors are recommended for these vertically terminated products which have excessive draft. Exhaust restrictors will compensate for high draft. and restore vi- sual flame height. If the vent configuration has a total ver- tical of 15 ft. - 44 ft. (4.6 m - 13.4 m), an exhaust restrictor may be needed. The exhaust restrictor can be located in the appliance manual bag.
Exhaust restrictor Instructions
1.Locate the two pilot holes located in the inside firebox heat shield as shown in Figure 7.6.
2.Center the exhaust restrictor such that the through holes in the vent restrictor align with the pilot holes in the heat shield.
3.Use (2) 1/2 in. (13 mm)
PILOT HOLES
Figure 7.6 Location of Pilot Holes
Figure 7.7 Exhaust Restrictor Installation
4.In some applications, such as those where the fire- place is elevated off the floor, the vent restrictor may be painted, but painting is not required.
NOTICE: Before painting, contact your dealer for informa- tion on the appropriate high temperature paint.
Heat & Glo • | 27 |