Heat & Glo LifeStyle XLR-N-AU, XLR-PB-AU manual Inside Fit Method Tonic Decorative Front Only

Non-Combustible Finish Materials

0 in. to 4 in. (0 mm to 102 mm) Thick Inside Fit Method

The Tonic decorative front is approved for inside fit ap- plications. Non-combustible finishing materials up to 4 in. (102 mm) thick can be installed around the front (left, right, top, and bottom).

For the Tonic decorative front inside fit applications, the decorative front must be installed tight to the finishing flanges and must not overlap any finish material.

Ensure that no non-combustible finish materials are in- stalled within 3/4 in. (19 mm) of the fireplace opening. The 3/4 in. (19 mm) spacing is required to provide clear- ance for removing and installing the Tonic decorative front. See Figure 13.14.

FACTORY-INSTALLED

NON-COMBUSTIBLE

BOARD

0-4 in.
(0-102 mm)		3/4 in.
	(19 mm)

20-1/2 in. (520 mm)

APPLIANCE

OPENING (HEIGHT)

3 in. (76 mm)

0-4 in. (0-102 mm)

DRYWALL OR EQUIVALENT 3/8 in. (10 mm)

Figure 13.13 Inside Fit Method (Tonic Decorative Front Only)

Non-Combustible Finish Material 0 - 4 in. (0 - 102 mm) Thick

3/4 in (19 mm) 3/4 in (19 mm)

3 in. (76 mm)

Bottom Joint

Figure 13.14 Noncombustible Surface Finishing Material 0 - 4 in. (0 - 102 mm) Thick-Inside Fit Method (Tonic Decorative Front Only)

Heat & Glo • XLR-N-AU, XLR-PB-AU • 2198-906 Rev. M • 5/12 51