INSTALLATION
CONVERSION KIT
FOR
THIS CONVERSION MUST BE DONE BY A QUALIFIED GAS FITTER IF IN DOUBT DO NOT DO THIS CONVERSION !!
Each Kit contains one LPG Conversion Kit and one DC Sparker Kit.
LPG Conversion Kit Contains:
11 ) Remove the black protection cap by hand from the
Qty. Part # | Description |
1
1
1
1
1
1
DC Sparker Kit Contains:
Qty. Part # | Description |
1
1
1
1
1
2
0.500 in
1
2
Black Oxid e
1
1
1
Energizer En91
Remove the 2 screws, push Burner Assembly to the left and lift out.
6)Pull off the pilot cap to expose the pilot orifi ce
7)Unscrew the pilot orifi ce with the allen key and replace with the LP pilot orifi ce in the kit and replace pilot cap.
Fig. 1
12)Insert a 5/32” or 4mm Allen wrench into the hexagonal
1
1
1
Installation of LPG
Conversion Kit:
1)Shut off the gas supply
2)Remove the louvers (and bay door if it is installed)
3)Open the fl ush door and remove the door
4)Remove the logs and embers
5)Remove the 2 screws holding the Burner Assembly to the fi rebox base. Push the Burner Assembly to the left and lift out
8)Remove burner orifice with a 1/2" wrench and discard. Use another wrench to hold on to the elbow behind the
orifi ce
Burner Orifice
9)Reinstall new burner orifice LP stamped #53 and tighten
10)Tu rn control knob to the “OF F” position
Fig.2
13)Check that the screw is clean and if necessary remove dirt.
14)Flip the screw (Fig. 3).
24 | UltraGlow® G36D Zero Clearance Direct Vent Gas Fireplace |