Regency Safety Label, Copy of Safety Decal for G36D-NG1, 300, Delta, BC, Canada

4

UltraGlow

For the State of Massachusetts, the appliances individual manual shut-off must be a t-handle type valve.	For the State of Massachusetts, fl exible connectors shall not exceed 36 inches in length.	For the State of Massachusetts, installation and repair must be done by a plumber or gasfi tter licensed in the Commonwealth of Massachusetts.	the correct one.	NOTE: UltraGlow® units are constantlybeing improved. Check the label on the unit andif there is a difference, the label on the unitis	This is a copy of the label thataccompanies each G36D Zero Clearance Direct VentGas Fireplace. We have printed a copy ofthe contents here for your review. The safetylabel is located on the front inside base of theunit, visible when the bottom louver is open.
			Copy of Safety Decal for G36D-NG1

	Duplicate S/N	300
Listed: VENTED GAS FIREPLACE HEATER	DO NOT REMOVE THIS LABEL / NE PAS ENLEVER CETTE ÉTIQUETTE
Certified for/Certifiée pour: CANADA and U.S.A.		Serial No./ No de serie
Tested to: Gas-Fired Appliances For Use At High Altitudes CAN/CGA-2.17-M91,
Vented Gas Fireplace Heaters ANSI Z21.88b-2003/CSA 2.33b-2003		300
Report No. 476-3031-977

	NATURAL GAS: Model G36D-NG1				APPAREIL FONCTIONNANT AU NATURAL GAZ	MAY BE INSTALLED IN MANUFACTURED (MOBILE)
	L				CONCU POUR ETRE POELE: Modéle G36D-NG1	HOMES AFTER FIRST SALE.
G36DNG1- Model/Modele:	Minimum supply pressure	5"	WC(1.25 kPa)		Pression d'allimentation minimum	Minimum Clearances to Combustibles /
	Manifold pressure high	3.8"	WC(0.95 kPa)		Pression à la tubulure d'échappement élevée
						Degagement Minimum De Materiaux Combustibles
	Manifold pressure low	1.1"	WC(0.27 kPa)		Pression à la tubulure d'échappement basse
	Orifice size	# 42	DMS		Grandeur de l'injecteur		0" Clearance to
	Minimum input	13,100	Btu/h	(4.54 kW)	Débit Calorifique minimum selon	Ceiling
							combustibles from:
	Maximum input	26,000	Btu/h	(8.79 kW)	Débit Calorifique maximum selon	32"	Top, sides, bottom and rear of unit
	Altitude	0-4500	ft/pi(0-1372 m)		l'altitude
							Mantel Clearances from Top:

SAFETY LABEL

® G36D Zero Clearance Direct Vent Gas Fireplace

	PROPANE: Model G36D-LP1				APPAREIL FONCTIONNANT AU GAZ PROPANE
	L				CONCU POUR ETRE POELE: Modéle G36D-LP1
G36D Model/Modele: LP1-	Minimum supply pressure	12"	WC(3.00 kPa)		Pression d'allimentation minimum
	Altitude	0-4500	ft/pi(0-1372 m)		l'altitude
	Manifold pressure high	11"	WC(2.74 kPa)		Pression à la tubulure d'échappement élevée
	Manifold pressure low	2.9"	WC(0.72 kPa)		Pression à la tubulure d'échappement basse
	Orifice size	# 53	DMS		Grandeur de l'injecteur
	Minimum input	13,800	Btu/h	(3.96 kW)	Débit Calorifique minimum selon
	Maximum input	26,000	Btu/h	(7.91 kW)	Débit Calorifique maximum selon

VENTING: This appliance must be installed in accordance with the manufacturer's installation instructions and with local codes, if any; if not, follow the current ANSI Z223.1 in the USA or the current CAN 1-B149 in Canada. For Manufactured Home Installation: This Direct Vent System Appliance must be installed in accordance with the manufacturer's installation instructions and Manufactured Home Construction and Safety Standard Title 24 CFR, Part 3280, or the current Standard for Fire Safety Criteria for Manufactured Home Installations, Sites, and CommunitiesANSI/NFPA501A, and with CAN/CSA Z240 MH Mobile Home Standard in Canada. This appliance is only for use with the type of gas indicated on the rating plate and may be installed in an aftermarket, permanently located, manufactured (mobile) home where not prohibited by local codes. See owner’s manual for details. This appliance is not convertible for use with other gases, unless a certified kit is used.

Not for use with solid fuel.

This vented gas fireplace is not for use with filters.

		A		(A) Min. 7" (177mm)
Wa	B	B	Wall	Side Wall Clearance
ll				from Side Facing
				B) 6" with Flush
				Alcove approved for
				Flush Louvers.
				Alcove Clearances:
				Max. Depth 36" (914mm)
	DOOR SEAL: Please			Min. Width 48" (1219mm),
	check that the door is			Min. Height 72" (1229mm)
		properly sealed		Minimum Vent Clearances:
				Horizontal Top	2-1/2" (64mm)
	(See Instruction Manual for			Horizontal Side	1-1/2" (38mm)
				Horizontal Bottom	1-1/2" (38mm)
		Detailed Instructions)
		FPI Fireplace Products International Ltd.
		Delta, BC, Canada
Made in Canada/Fabrique au Canada					918-493