Wayne CWS75, CWS50 warranty Convertible Well Jet Pump Water Systems, Description, Unpacking

Page 1
Operating Instructions and Parts Manual

Operating Instructions and Parts Manual

CWS50, CWS75 and CWS100

 

 

Please read and save these instructions. Read carefully before attempting to assemble, install, operate or maintain the product described. Protect yourself and others by observing all safety information. Failure to comply with instructions could result in personal injury and/or property damage! Retain instructions for future reference.

Convertible Well Jet

Pump Water Systems

Description

Jet pumps are single stage domestic water pumps designed for pumping potable water in applications where the water is up to 100 feet (deep well pump). A pressure switch is a standard feature. A built-in control valve is available on deep well pumps. Deep well pumps can be mounted to either a pre-charged, conventional type or free standing pressure tank.

Unpacking

After unpacking the jet pump, carefully inspect for any damage that may have occurred during transit. Check for loose, missing or damaged parts.

Safety Guidelines

This manual contains information that is very important to know and understand. This information is provided for SAFETY and to PREVENT EQUIPMENT PROBLEMS. To help recognize this information, observe the following symbols.

Danger indicates an imminently

hazardous situation which, if not avoided, WILL result in death or serious injury.

Warning indicates a potentially

hazardous situation which, if not avoided, COULD result in death or serious injury.

Caution indicates a potentially

hazardous situation which, if not avoided, MAY result in minor or moderate injury.

Notice indicates important

information, that if not followed, may cause damage to equipment.

NOTE: Information that requires special attention.

General Safety

Information

CALIFORNIA PROPOSITION 65

This product contains chemicals,

including lead, known to the State of California to cause birth defects and other reproductive harm. Wash hands after handling.

GENERAL SAFETY

1.Read all manuals included with this product carefully. Be thoroughly familiar with the controls and the proper use of the equipment.

2. Know the pump application, limitations and potential hazards.

Always install a pressure relief valve

to match the system pressure rating and the maximum flow rate.

Do not use to pump flammable

or explosive fluids such as gasoline, fuel oil, kerosene, etc. Do not use in explosive atmospheres. Pump should only be used with liquids compatible with pump component materials.

Failure to follow this warning can result in personal injury and/or property damage.

Disconnect power and release all

pressure from the system before attempting to install, service, relocate or perform any maintenance. Lock the power disconnect in the open position. Tag the power disconnect to prevent unexpected application of power.

Install a screen around the inlet pipe

to prevent entrapment of swimmers.

3.Drain all liquids from the system before servicing.

4.Secure the discharge line before starting the pump. An unsecured discharge line will whip and possibly cause personal injury and/or property damage.

5.Check hoses for weak or worn condition before each use. Make certain all connections are secure.

6.Periodically inspect pump and system components. Perform routine maintenance as required (See Maintenance).

7.Personal Safety:

a.Wear safety glasses at all times when working with pumps.

b.Keep work area clean, uncluttered and properly lighted replace all unused tools and equipment.

c.Keep visitors at a safe distance from work area.

d.Make the workshop child proof: use padlocks, master switches and remove starter keys.

8.Do not pump chemicals or corrosive liquids. Pumping these liquids shortens the life of the pumps seals and moving parts and will void the warranty.

9.When installing pump, cover the well to prevent foreign matter from falling into well and contaminating the water and damaging internal mechanical pumping components.

10.Always test the water from the well for purity before use. Check with local health department for test procedure.

11.Complete pump and piping system MUST be protected against below freezing temperature. Freezing temperatures could cause severe damage and void the warranty.

REMINDER: Keep your dated proof of purchase for warranty purposes!

Attach it to this manual or file it for safekeeping.

© 2009 Wayne Water Systems

For parts, product & service information

340006-001 3/09

 

visit www.waynepumps.com

 

Image 1
Contents General Safety Information Safety GuidelinesGENERAL SAFETY 7.Personal SafetyPre-Installation General Safety Information ContinuedPRESSURE SWITCH CWS50, CWS75 and CWS100SHALLOW WELL INSTALLATION InstallationContinued PACKAGE SYSTEMSDEEP WELL INSTALLATION Installation ContinuedCWS50, CWS75 and CWS100 Operating Instructions & Parts ManualInstallation Continued ElectricalElectrical Continued MaintenanceOperation PRIMING THE SHALLOW WELL PUMPINSTALLING NEW SHAFT SEAL Maintenance ContinuedPRE-CHARGEDTANK LUBRICATIONC DUG WELL ASPRING BLAKE STREAM, PONDE DRILLED WELL D DRIVEN WELLCWS50, CWS75 and CWS100 Troubleshooting ChartOperating Instructions & Parts Manual Please provide following information Replacement Parts ListAddress any correspondence to Model numberPerformance ATTACH YOUR RECEIPT HERE Limited WarrantyCWS50, CWS75 and CWS100 Operating Instructions & Parts ManualDéballage Puit convertible Systèmes DEau De Pompe À JetDirectives de Sécurité Généralités Sur La SécuritéGénéralités Sur La Sécurité Suite Pré-InstallationCWS50, CWS75 et CWS100 Instructions D’utilisation et Manual de PiècesINSTALLATION DE PUITS DE SURFACE Pré-Installation SuiteSYSTÈMES EN PAQUETS PUITSINSTALLATION POUR PUITS PROFOND Installation Suite16-Fr CWS50, CWS75 et CWS10017-Fr Électrique SuiteInstallation Suite CWS50, CWS75 et CWS100Entretien FonctionnementAMORÇAGE DE LA POMPE POUR PUITS DE SURFACE AMORÇAGE DE LA POMPE POUR PUITS PROFONDEntretien Suite INSTALLATION D’UN NOUVEAU JOINT D’ARBRERÉSERVOIRS SATURÉS D’EAU CHARGÉS D’AVANCE RÉSERVOIR CHARGÉ D’AVANCEE PUITS FORÉ C PUITS CREUSÉÀ EAU D PUITS ENFONCÉ21-Fr Tableau de dépannageCWS50, CWS75 et CWS100 Instructions D’utilisation et Manual de PiècesS’il vous plaît fournir l’information suivante Liste de pièces de rechangeAdresser toute correspondance à 22-FrPerformance 23-FrPression de Décharge kPa 12,224-Fr Garantie LimitéeCWS50, CWS75 et CWS100 Instructions D’utilisation et Manual de PiècesBomba de Chorro Pozo convertible Sistemas de Agua ConDescripción Para DesempacarCWS50, CWS75, y CWS100 Pre-InstalaciónManual de instrucciones de operación y piezas FUENTES DE SUMINISTRO DE AGUAInstalación Pre-Instalación ContinuedPAQUETES DE SISTEMAS POZOSINSTALACIÓN EN UN PROFUNDO Instalación Continued28-Sp CWS50, CWS75, y CWS10029-Sp EléctricasInstalación Continued CWS50, CWS75, y CWS100Mantenimiento FuncionamientoCEBADO DE LA BOMBA PARA POZOS POCO PROFUNDOS CEBADO DE LA BOMBA PARA POZOS PROFUNDOSDRENAJE DEL TONQUE Eléctricas ContinuedPRECARGADO PARA VOLVER A HACER FUNCIONAR LA BOMBAMantenimiento 32-SpCWS50, CWS75, y CWS100 Continued33-Sp Tabla de Identificación de ProblemasCWS50, CWS75, y CWS100 Manual de instrucciones de operación y piezasSirvase darnos la siguiente información Lista de Partes de ReparaciónDirija toda la correspondencia a Número del modelo35-Sp RendimientoPresión de Descarga bar 1,38ANEXE SU RECIBO AQUI Garantía Limitada36-Sp CWS50, CWS75, y CWS100