Hearth and Home Technologies QV36B-A, QV32B-A owner manual Junction Box Installation

E. Junction Box Installation

If the box is being wired from the INSIDE of the appliance:

•Remove the screw attaching the junction box/receptacle to the outer shell, rotate the junction box inward to disengage it from the outer shell (see Figure 12.2).

•Pull the electrical wires from outside the appliance through the opening into the valve compartment and secure wires with a Romex connector. See Figure 12.2.

•Make all necessary wire connections to the junction box/ receptacle and reattach the junction box/receptacle to the outer shell.

F. Wall Switch Installation for Fan (Optional)

If the box is being wired to a wall mounted switch for use with a fan (See Figure 12.3):

•The power supply for the appliance must be brought into a switch box.

•The power can then be supplied from the switch box to the appliance using a minimum of 14-3 with ground wire.

•At the switch box connect the black (hot) wire and red (switch leg) wire to the wall switch as shown.

•At the appliance connect the black (hot), white (neutral) and green (ground) wires to the junction box as shown.

•Add a 1/4 in. insulated female connector to the red (switch leg) wire, route it through the knockout in the face of the junction box, and connect to the top fan switch connector (1/4 in. male) as shown.

	Romex
	Connector
	14/2WG
	Cover Plate
	outside firebox
WHT
BLK
WHT
BLK	Copper
GRN wire	ground attached
	to GRN screw with
inside box
	GRN wire
NOTICE: DO NOT wire
110 VAC to wall switch.
Figure 12.4 Junction Box Detail

Minimum 14-3 AWG		Switch
with Ground
	Red
	Black	Black
	White	White
Junction Box	Green	Green
Red Black White Green		Power
	Switch Box
		Supply
		Wires
	Knockout
Red
Figure 12.3 Junction Box Wired to Wall Switch or BC10

Quadra-Fire • QV32B-A, QV36B-A • 2014-900 Rev. U • 1/12 51