Hearth and Home Technologies ST-HVB-CE, RCOR-HVB-CE, PIER-HVB-CE, LCOR-HVB-CE Table of Contents

Page 3

Table of Contents
Safety and Warning Information	2
Service Parts List	4
Section 1: Approvals and Regulations	13
Appliance Certification	13
Installation Regulations	13
Section 2: Getting Started	13
Introducing the Heat & Glo Gas Fireplaces	13
Pre-install Preparation	13
Section 3: Installing the Fireplace	17
Step 1. Locating the Fireplace	17
Step 2. Framing the Fireplace	17
Step 3. Installing the Flue System	20
A. Flue System Approvals	20
B. Installing Flue Components	27
C. Flue Termination	29
Step 4. Positioning, Leveling, and Securing the Fireplace	32
Step 5. The Gas Control System	32
Step 6. The Gas Supply Line	33
Step 7. Gas Pressure Requirements	33
Step 8. Wiring the Fireplace	34
Step 9. Finishing	34
Step 10. Installing Trim, Logs & Ember Material	35
Installing the Trim	35
Positioning the Logs	35
Attachment of Lower Door Assembly	35
Placing the Ember Material	38
Step 11. Before Lighting the Fireplace	41
Step 12. Lighting the Fireplace	41
After the Installation	41
Section 4: Maintaining and Servicing Your Fireplace	42
Section 5: Troubleshooting	43
Î = Contains updated information.

Heat & Glo • PIER/ST/L&RCOR-HVB-CE • 2068-900 Rev. H • 6/07

3

Image 3

Contents 0087 Safety and Warning Information Table of Contents PIER-HVB-CE PIER-HVB-CE NG, LP Exploded Parts DiagramST-HVB-CE ST-HVB-CE LCOR-HVB-CE LCOR-HVB-CE RCOR-HVB-CE RCOR-HVB-CE RCOR-HVB-CE Í Valve AssemblyCertification Installation RegulationsPre-install Preparation Appliance CertificationHeat & Glo PIER/ST/L&RCOR-HVB-CE 2068-900 Rev. H 6/07 Diagram of the PIER-HVB-CEDiagram of the ST-HVB-CE Diagram of the LCOR-HVB-CE and RCOR-HVB-CE Clearance Requirements Fireplace Dimensions and LocationsLocating the Fireplace Framing the FireplaceModel AT Each Joint Terminations Kits Installing the Flue SystemFlue System Approvals Identifying Flue ComponentsMax. Run Straight OUT HorizontalflueingFlueing with One 90 Elbow Flueing with Two 90 Elbows Propane / Butane Flueing with TWO 90 Elbows Flueing with three 90 elbows + H1 FT + V1 FT Attach the First Flue Component to the Starting Collars Installing Flue ComponentsInstall Support Brackets Continue Adding Flue ComponentsCombustibles inside the framed firestop opening Trapezoid Termination Cap Ceiling Firestop Ceiling SideMinimum Height from Roof to Lowest Discharge Opening Vent Termination Minimum Clearances Positioning, Leveling, and Securing the Fireplace Gas Control SystemSecuring of a Fireplace Gas Supply Line Gas Pressure RequirementsNatural Gas Finishing Wiring the FireplaceOptional Accessories Wall SwitchAttachment of Lower Door Assembly Installing Trim, Logs & Ember MaterialLog placement Installing the TrimHeat & Glo PIER/ST/L&RCOR-HVB-CE 2068-900 Rev. H 6/07 Heat & Glo PIER/ST/L&RCOR-HVB-CE 2068-900 Rev. H 6/07 Only for Model LCOR-HVB-CE 3 4Heat & Glo PIER/ST/L&RCOR-HVB-CE 2068-900 Rev. H 6/07 Heat & Glo PIER/ST/L&RCOR-HVB-CE 2068-900 Rev. H 6/07 Lighting the Fireplace After the InstallationDouble-check for faulty components Before Lighting the FireplaceChecking Flame Patterns, Flame Height Fireplace MaintenanceCleaning Glass Door Replacing old ember material5Troubleshooting Be Placed in this Opening Troubleshooting