Step 8. Wiring the Fireplace
NOTE: Electrical wiring must be installed by a licensed electrician.
For Standing Pilot Ignition Wiring
Appliance Requirements
Optional Accessories
Optional remote control kits require that 230 VAC be wired to the facto- ry installed junction box before the fireplace is permanently installed.
Wall Switch
Position the wall switch in the desired position on a wall. Run a maximum of 780cm or less length of 0.102 cm diameter minimum wire and connect it to the fireplace ON/OFF switch pigtails.
!WARNING: DO NOT CONNECT 230 VAC TO THE GAS CONTROLVALVE
OR THE APPLIANCE WILL MALFUNC- TION AND THE VALVE WILL BE DE- STROYED.
CAUTION: LABEL ALL WIRES PRIOR TO DIS- CONNECTION WHEN SERVICING CON- TROLS. WIRING ERRORS CAN CAUSE IM- PROPER AND DANGEROUS OPERATION. VERIFY PROPER OPERATION AFTER SER- VICING.
Step 9. Finishing
Figure 30 shows the minimum vertical and corresponding maximum horizontal dimensions of fireplace mantels or other combustible projections above the top front edge of the fireplace. See Figures 4 and
5for other fireplace clearances. Only non-combustible materials may be used to cover the black fireplace front.
! | WARNING: WHEN FINISHING THE FIREPLACE, NEVER |
OBSTRUCT OR MODIFY THE AIR INLET/OUTLET GRILLES | |
| IN ANY MANNER. |
|
|
CAUTION: IF JOINTS BETWEEN THE FIN- ISHED WALLS AND THE FIREPLACE SUR- ROUND (TOP AND SIDES) ARE SEALED, A 150° C. MINIMUM SEALANT MATERIAL MUST BE USED. THESE JOINTS ARE NOT REQUIRED TO BE SEALED. ONLY NON- COMBUSTIBLE MATERIAL (USING 150° C.
MINIMUM ADHESIVE, IF NEEDED) CAN BE APPLIED AS FACING TO THE FIREPLACE SURROUND (SEE FIGURE 31).
| MANTEL | 305mm | |
|
| 280mm | |
| 254mm | ||
| 228mm |
| |
| 204mm |
| |
| 178mm |
| |
| 153mm | 407mm | |
| 127mm | ||
| 381mm | ||
102mm | |||
356mm | |||
|
| ||
77mm |
| 331mm | |
51mm |
| 305mm | |
280mm | |||
25.4mm | |||
254mm |
| ||
| 229mm |
| |
| 204mm |
| |
| 178mm |
| |
153mm |
| ||
127mm |
|
| |
HOOD
NOTE: 305mm (12 in.) mantel at 407mm (16 in.) above hood.
Figure 30. | Minimum Vertical and Maximum Horizontal |
Dimensions of Combustibles above Fireplace |
NOTE: Sheetrock or other combustible material such as wood can be placed on the top edge and sides of the fireplace.
| |
| TOP EDGE |
| SIDE EDGE |
| 0” GAP |
| TOP EDGE |
| SIDE EDGE |
| 0” GAP |
Figure 31. | Sealant Material |
34 | Heat & Glo • |