Kenmore 385.162213 owner manual Sewing, Overcasting, Button

Button		Sewing	f
(_	Stitch	selector:	3
®	Stitch	width:	2 to 65
®	Stitch length:		Any
(_	Needle thread tension:		2 to 6
®	Presser foot A:		Zigzag foot
®	Feed dogs:		Dropped

1.Drop the feed dogs Place the button below the zigzag foot, making sure to align the holes with the horizontal slot in the fool Lower the presser foot to hold the button in place

2.Determine which stitch width setting matches the distance between the button holes. The needle must go safely through each hole when sewing.

Unthread the needle to help you determine the zigzag width

3Thread the needle Turn the handwheel, so that the needle is in its leftmost position, and then drop the

needle through the left buttonhole.

4. Press the foot control and sew about 10 stitches.

5Sew the other row of holes (if applicable) using the steps above. Trim excess threads from both sides of the fabric.

Overcasting

	Stitch	selector:		3
®	Stitch	width:		5 to 6.5
(_	Stitch	length:		Red zone
(_	Needle		thread tension:	3 to 8
®	Presser		foot A:	Zigzag foot
®	Presser		foot C:	Overedge foot
®	Brush	holder seam guide

f

O

_ m LEI_GTM

®®®

J

J

®

%° orOU

J

This stitch is useful in garment construction, and in finishing raw edges of any sewing project

If using the zigzag foot, start overcasting with the leftmost needle position about 1/8" (0.3 cm) from the raw edge of a seam The right tip of the stitch should just clear the seam edge.

S

For lightweight fabrics, use the overedge foot To sew, line the fabric edge up with the inner side of the brush holder seam guide(_.

J

54