Fostex CR300 owner manual Track recording

AUTOMATIC DIGITAL-SOURCE SYNCHRO RECORDING

A. 1-track recording

When the source equipment starts to play, only one track is recorded automatically and the recording stops automatically after that track. This mode is convenient for edited recording of a CD, DAT, MD or DCC(only S/P DIF).

After loading the disc, check that the CD-R or CD-RW indicator stops blinking and starts to light steadily. In case it does not light steadily, refer to page 42.

•	The AES/EBU digital input cannot be
	recorded with this function.
• The ANALOG input cannot be recorded
	with this function.
• Confirm the track to be recorded before
	recording.
•	Every time the DIGITAL SYNCHRO
	button is pressed, the mode is changed
	in order of 1-SYNC ➔ AL-SYNC ➔
	Record-pause mode.
	Select "AL-SYNC" when all-track
	recording is required.
	• Do not start the playback of the

1 4	2
		REC
	FADER	TRACK NO.
		WREITE
	REPEAT
	7
1	Load a CD-R or CD-RW	Label side
	disc containing a record-
	able space.

For a disc loading, refer to page 15.

2	Set the INPUT SELECTOR	INPUT SELECTOR
		DIGITAL	ANALOG
	to DIGITAL.	•	XLR/+4
			• •
		COAX	XLR/-10
	Select OPTICAL or COAXIAL.	OPT •	• LINE
		AESEBU/ •

3

Ensure that the source player is not playing (in stop or pause mode).

•This function cannot be activated if the source is being played.

4 Press the DIGITAL	Wait until the SYNC indicator blinks.
SYNCHRO button.
• Check the copy bit indicator
(refer to page 24).	Blinks

5

Start playing the source player.

source player until the SYNC

indicator starts to blink.

• If the SYNC indicator is not lit after 1-

track synchro recording, the track to be

recorded next can be confirmed on the

source player.(Automatic recording

cannot be started while the SYNC

indicator is not lit.)

6

•This unit starts recording automatically.

•The SYNC indicator is flashing (1-track synchro recording standby), or during 1-track synchro recording, if the input signal is interrupted or the source is switched to a source for which auto synchro recording is not possible, the 1-track synchro recording mode will be canceled and the unit will enter the record-pause mode.

If the track changes (when input source is CD or Mini Disc), or if the next start ID is detected (when input source is DAT or DCC), 1-track recording will be cancelled and the unit will en- ter the record-pause mode. The 1-track recording mode is also cancelled if no signal (less than -90dB) condition lasts for the length set by the MENU button functions.(See page 24)

SYNC indicator is not lit.

• If it is required to record another track after 1-track recording, repeat steps 3 to 5 again.

7

After recording, press the stop ( ) button to end recording.

"PMA REC" is displayed and the unit stops after recording the track data.

18

CR300 <PRB1291-A>