Fostex CR300 All-track recording, Load a CD-R or CD, RW disc containing Recordable space

B. All-track recording

When the source equipment starts to play, all tracks are recorded automatically and the recording stops automatically after the last track. This mode is convenient for recording an entire CD, DAT, MD or DCC(only S/P DIF).

•After loading the disc, check that the CD-R or CD-RW indicator stops blinking and starts to light steadily.

In case it does not light steadily , refer to page 42.

•The AES/EBU digital input cannot be recorded with this function.

•The ANALOG input cannot be recorded with this function.

•Confirm the track to be recorded before recording.

•Every time the DIGITAL SYNCHRO button is pressed, the mode is changed in order of 1-SYNC ➔ AL-SYNC ➔ Record-pause mode.

Select "AL-SYNC" when all-track recording is required.

•Do not start the playback of the source player until the SYNC indicator starts to blink.

•The source unit stops playback and after no signal(less than - 90dB) condition lasts for the length set by the MENU button functions(see page 24), the unit reverts to the status noted in step 4 and "AL-SYNC" is displayed again.

Be careful not to restart playback of the source player under this condition, for this will start the recording again.

1 4	2
			REC
		FADER	TRACK NO.
			WREITE
		REPEAT
	6
1 Load a CD-R or CD-		Label side
	RW disc containing
	a recordable space.
	For a disc loading, refer to
	page 15.
2 Set the INPUT SELECTOR		INPUT SELECTOR
		DIGITAL	ANALOG
	to DIGITAL.	XLR/+4	•
		• •
		COAX	XLR/-10
	Select OPTICAL or COAXIAL.	OPT •	• LINE
		AESEBU/ •

3 Ensure that the source player is not playing (in stop or pause mode).

• This function cannot be activated if the source is being played.

4 Press the DIGITAL Wait until the SYNC indicator blinks.

SYNCHRO button.

• Check the copy bit indicator
(refer to page 24).	Blinks

5 Start playing the source player.

•This unit starts recording automatically.

•When the SYNC indicator is flashing (all-track synchro recording standby), or during all- track synchro recording, if the input signal is interrupted or the source is switched to a source for which auto synchro recording is not possible, the all-track synchro recording mode will be canceled and the unit will enter the record-pause mode.

6 After recording, press the stop ( ) button to end recording.

"PMA REC" is displayed and the unit stops after recording the track data.

CAUTION

•Do not play the DAT or DCC of the source player with programmed playback, for this may lead to incorrect writing of the track numbers. If programmed playback should be recorded, record each track separately using the 1-track recording procedure.

•The track number is renewed when a start ID is detected during all-track synchro recording from DAT or DCC.

•When performing all-track synchro recording from a CD or Mini Disc player using normal playback, the track number is renewed just as the track changes on the playback side. When the CD or Mini Disc player is in the programmed playback mode, however, the track number is not renewed until the first sound is encountered after the track changes.

19

CR300 <PRB1291-A>