Craftsman 139.53920D owner manual Important Safety ,NSTRUCTIONS, Using Your Garage Door Opener

OPERATmON

i i i llll i i = =

IMPORTANT SAFETY ,NSTRUCTIONS

To reduce the risk of SEVERE iNJURY or DEATH:

1.READAND FOLLOWALL WARNINGSAND INSTRUCTIONS

2ALWAYSkeepremotecontrols out of reach of children. NEVERpermitchildren to operateor play with garage door contro_push buttons or remotecontrols

3.ONLYactivategaragedoor when it can beseenctearly,it

is properly adiusted,andthere areno obstructionsto door travel.

4.ALWAYSkeepgaragedoor in sight unti! completely closed. NOONESHOULDCROSSTHEPATHOF]HE MOVINGDOOR

5.NOONESHOULDGOUNDERA STOPPED,PARTIALLY OPENEDDOOR.

6if possible, useemergencyreleasehandieto disengage trolley ONLYwhen garagedoor is CLOSEDWeakor brokensprings or unbalanceddoor could resultin an opendoorfailing rapidly and/or unexpectedly

7.NEVERuseemergencyreleasehandleunlessgarage doorway is clearof personsandobstructions

8.NEVERusehandleto pull garagedoor openor closed if ropeknot becomesuntied,you couidfall.

g.if one control (forceor travel limits) is adjusted,the other control mayalso needadiustment

l& After ANYadjustmentsare made,the safety reversal system MUSTbetested

tl. Safetyreversaisystem MUSTbetested everymonth. Garagedoor must reverseon contactwith 1-1/2" high (3 8 cm) object(or a 2x4 laid flat) on the floor

12, ALWAYSKEEPGARAGEDOORPROPERLYBALANCED

(seepage3) An improperlybalanceddoor may not reversewhen requiredandcould resultin SEVERE iNJURYor DEATH_

13.Ali repairsto canes, spring assembliesand other hardware,all of which areunder EXTREMEtension, MUSTbemadeby a trained door systemstechnician

14.ALWAYSdisconnectelectricpowerto garagedoor

openerBEFOREmakingany repairsor removing

covers.

SAVETHESEINSTRUCTIONS.

Using Your Garage Door Opener

Your Security+ _ opener and hand-held remote control have been factory-set to a matching code which changes with each use, randomly accessing over 100 billion new codes. Your opener will operate

with up to eight Security÷ _ remote controls and one Security÷ _ Keyless Entry System. If you purchase a new remote, or if you wish to deactivate any remote, follow the instructions in the Programming section.

Activate your opener with any of the following:

. The hand-held Remote Control,:'Hold the large push button down until the door starts to move

•The wall-mounted Door Control,: Hold the push button or bar down until the door starts to move.

•The Keyless Entry (See Accessories): If provided with your garage door opener, it must be programmed before use_See Programming..

When the opener is activated (with the safety reversing sensor correctly installed and aligned)

1..If open, the door wil! close. If closed, it will open. 2..If closing, the door wil! reverse.

3. If opening, the door will stop

4If the door has been stopped in a partially open position, it will close.

5.If obstructed while closing, the door will reverse., if the obstruction interrupts the sensor beam, the opener lights will blink for five seconds.

6, If obstructed while opening, the door will stop.

7.If fully open, the door will not close when the beam is broken. The sensor has no effect in the opening cycle

If the sensor is not installed, or is misaligned, the door won'tclose from a hand-held remote. However, you can close the door with the Door Control, the Outdoor Key Switch, or Keyless Entry, ffyou activate them until down travel is complete If you release them too soon, the door will reverse.

The opener lights will turn on under the following conditions: when the opener is initially plugged in; when power is restored after interruption; when the opener is activated

They will turn off automatically after 4-1/2 minutes Bulb size is A19. Bulb power is 75 watts maximum.

3O