Craftsman 139.53920D To set a temporary PiN, To Add, Reprogram or Change a Keyless Entry PiN

To Add, Reprogram or Change a Keyless Entry PiN

NOTE: Your new Keyless Entry must be programmed to operate your garage door opener.

USING THE "LEARN" BUTTON

To change an existing, known PIN

If the existing PIN is known, it may be changed by one person without using a [adder

1. Press the four buttons for the present PIN, then press and hold the # button

The opener light will blink twice Release the # button..

1.Press and release the "learn" button on motor unit The learn

indicator light will glow steadily for 30 seconds.

2 Within 30 seconds, enter a four digit personal identification

number (PIN) of your choice on

the keypad Then press and hold the ENTER button.

3, Release the button when the motor unit lights blink It has learned the code. If light bulbs are not installed, two ct[cks will be heard.

One Button Close

Opener can be closed by pressing only the ENTER button if the one button close feature has been

activated This feature has been activated at the

factory.. To activate or deactivate this feature press and hold buttons 1 and 9 for 10 seconds The

keypad will blink twice when the one button close is

active The keypad will blink four times when one button close is deactivated..

2, Press the new 4-digit PIN you have chosen, then press Enter,

The motor unit Iights will blink once when the PIN has been ]earned,,

Test by pressing the new PIN, then press Enter: The door should move,,

To set a temporary PiN

You may authorize access by visitors or service people with a temporary 4-digit PIN. After a programmed number of hours or number of accesses, this temporary PIN expires and wilt no longer open the door. It can be used to close the

door even after it has expired. To set a temporary PIN:

1, Press the four buttons for your personal entry PIN (not the last temporary PIN), then press and hold the "[" button,

The opener light will blink three times, Release the button,

2 Press the temporary 4-digit PIN you have chosen, then press Ente_

The opener light wili blink four times°

3, To set the number of hours this temporary PIN will work, press the number of hours (up to 255), then press ;_.,

OR

3.To set the number of times this temporary PIN will work, press the number of times (up to 255), then press #.

The opener light will blink once when the temporary PIN has been learned..

Test by pressing the four buttons for the temporary PIN, then press Enter. The door should move. If the temporary PIN was set to a certain number of openings, remember that the test has used up one opening.To clear the temporary password, repeat steps 1-3, setting the number of hours or times to 0 in step 3

36