Install Chimney Covers
Vented Installation Option
1.Attach the vent system to the damper. Seal all joints with duct tape.
2.Remove the plastic covering from the chimney covers.
3.Slide the upper chimney cover over the chimney support and attach to the top of the support using two screws provided.
A
B 
C
A. Upper chimney cover
B. Lower chimney cover
C.Screw
4.Slide the lower chimney cover over the chimney support and the upper cover. Attach to the bottom of the support using two screws provided.
Recirculating Installation Option, Kit Required
1.Remove the plastic covering from the chimney covers.
2.Slide the upper chimney cover over the chimney support and attach to the top of the support using two screws provided.
3.Place the diverter from the Recirculating Chimney Kit over the vent motor exhaust outlet and push down to seat on the outlet. Make sure the diverter exhaust outlets are parallel with the vent motor sides so that they will align with the vent cover openings in lower chimney.
A 
B
A.Diverter
B.Vent motor
4.Install the two vent extension pieces onto the diverter, pushing them until they stop.
AA
A. Vent extensions
5.Discard the lower chimney cover shipped with the hood and use the cover from the Recirculating Kit (purchased separately).
6.Slide the recirculating kit lower chimney cover over the chimney support and the upper cover. Make sure the diverter extensions line up with the openings in the cover. Attach the cover using the two screws provided.
7.Snap vent grilles into place.
A
A. Vent grill location
Chimney Extension Kit Installation (Optional)
1.Remove the plastic covering from the chimney covers.
2.Discard the upper chimney cover supplied with the hood.
9