Hotpoint 25, 20, 22 manuel dutilisation Care and cleaning of the refrigerator

Care and cleaning of the refrigerator. www.Hotpoint.com

Cleaning the Outside

The dispenser drip area, (on some models) beneath the grille, should be wiped dry. Water left in this area may leave deposits. Remove the deposits by adding undiluted vinegar to the well. Soak until the deposits disappear or become loose enough to rinse away.

The dispenser cradle (on some models). Before cleaning, lock the dispenser by pressing and holding the LOCK CONTROL pad for 3 seconds. Clean with warm water and baking soda solution—about a tablespoon (15 ml) of baking soda to a quart (1 l) of water. Rinse thoroughly and wipe dry.

The door handles and trim. Clean with a cloth dampened with soapy water. Dry with a soft cloth.

Keep the outside clean. Wipe with a clean cloth lightly dampened with kitchen appliance wax or mild liquid dish detergent. Dry and polish with a clean, soft cloth.

Do not wipe the refrigerator with a soiled dish cloth or wet towel. These may leave a residue that can erode the paint. Do not use scouring pads, powdered cleaners, bleach or cleaners containing bleach because these products can scratch and weaken the paint finish.

Safety Instructions Operating

Cleaning the Inside

To help prevent odors, leave an open box of baking soda in the refrigerator and freezer compartments.

Unplug the refrigerator before cleaning. If this is not practical, wring excess moisture out of sponge or cloth when cleaning around switches, lights or controls.

Use warm water and baking soda solution— about a tablespoon (15 ml) of baking soda to a quart (1 l) of water. This both cleans and neutralizes odors. Rinse and wipe dry.

After cleaning the door gaskets, apply a thin layer of petroleum jelly to the door gaskets at the hinge side. This helps keep the gaskets from sticking and bending out of shape.

Drain opening in freezer compartment. During yearly cleaning, remove bottom freezer pan and flush a solution of baking soda—1 teaspoon (5 ml) and 2 cups (500 ml) of hot (not boiling) water— through the drain line with the help of a meat baster. This will help eliminate odor and reduce the likelihood of a clogged drain line. If drain becomes clogged, use a meat baster and baking soda solution to force the clog through the drain line.

Avoid cleaning cold glass shelves with hot water because the extreme temperature difference may cause them to break. Handle glass shelves carefully. Bumping tempered glass can cause it to shatter.

Do not wash any plastic refrigerator parts in the dishwasher.

Instructions Installation Instructions

Behind the Refrigerator

Be careful when moving the refrigerator away from the	Pull the refrigerator straight out and return it to position by
wall. All types of floor coverings can be damaged,	pushing it straight in. Moving the refrigerator in a side
particularly cushioned coverings and those with embossed	direction may result in damage to the floor covering or
surfaces.	refrigerator.
	When pushing the refrigerator back, make sure you don’t roll over
	the power cord or icemaker supply line (on some models).

Preparing for Vacation

For long vacations or absences, remove food and unplug	Set the icemaker power switch to the O (off) position and
the refrigerator. Clean the interior with a baking soda	shut off the water supply to the refrigerator.
solution of one tablespoon (15 ml) of baking soda to one
quart (1 l) of water. Leave the doors open.

Preparing to Move

Secure all loose items such as grille, shelves and drawers by taping them securely in place to prevent damage.

Be sure the refrigerator stays in an upright position during moving.

Replacing the Light Bulbs

NOTE: Turning the refrigerator to the 0 (off) setting via the controls does not shut off electrical power to the refrigerator.

Unplug the refrigerator.	Replace with an appliance bulb of the same
	or lower wattage.

Troubleshooting Tips Consumer Support

Remove the shelf just below the light shield.

Reinstall the shelf and plug the refrigerator	9
back in.